Electronics 500-P User Manual

MODEL 500P MagnaValve

• Wheel systems

• Variable flow rates

• No moving parts

• Steel shot

• Steel grit

• ±2% Accuracy

• Built-in flow sensor

• Linear compensator

• 200-1200 lbs/min range

• Normally closed

• Requires FC Flow Controller

999215

The Model 500P MagnaValve is a normally closed magnetic valve suitable for regula­tion of cast steel shot and includes a built-in sensor for accurate measurement of flow
rate. Used with the Model FC Shot Flow Controller, the MagnaValve will provide accu­rate and repeatable flow rates over a 200 - 1200 pounds-per-minute flow range.

The valve construction includes a permanent magnet for normally closed operation
and an electromagnet for controlling shot flow rates. By regulating the voltage to the
electromagnet, any desired flow rate may be achieved. When power is off, the valve
will hold shot due to the permanent magnet. The pre-amp includes a 9-stage linearity
compensator to achieve ±2% accuracy.

For use with stainless steel cut-wire shot contact the factory. The valve will work with
some of the larger sizes of stainless steel cut-wire shot.

The 500P will NOT work with stainless steel cast shot.

ELECTRONICS INCORPORATED

www.electronics-inc.com

SHOT PEENING TECHNOLOGY

500Pdata.pub 8/19/2008

MODEL 500P MagnaValve

Specifications

Sensor
Power: ±12Vdc from FC Control
Display: 4-digit
Output: 0-5Vdc to FC Control
Adjustments: Zero, Span, Linearity
Accuracy: ±2% (of Full Scale)

Valve
Power: +55Vdc @.5A from FC Control
Maximum Flow: 1200 lbs/min (500kg/min)
Range: 200-120lbs/min (100-500kg/min)
Temp: 0-75° C (70-110°F)

We will calibrate the MagnaValve at the factory prior
to shipment. Please specify the type and size of me­dia that you will be using with each valve. If your
maximum expected flow rate is less than 1200 lbs/
minute or 500 kg/minute you may request a lower
range setting. This will improve the valve accuracy
at your actual operating conditions.

MagnaValve

Range

Lbs/minute 200-1200 1200

150-1000 1000
125-800 800
90-600 600

Kg/minute 75-500 500

60-400 400
50-350 350
45-300 300

FC Control
Full Scale Display

Be sure to specify the FC Control Full Scale Display
range when you place your order for the control.

500Pdata.pub 8/19/2008

56790 Magnetic Drive, Mishawaka, IN, USA 46545 [phone]