Electrolux Z5305 Operating Instructions Manual

OPERATING INSTRUCTIONS
Z5305
GB
Contents
Safety information........................................................................................................................4
Exploded view and assembly......................................................................................................5
Vacuum cleaning ...........................................................................................................................6
Emptying dust collector/cleaning filters................................................................................8
Transport and storage ..................................................................................................................9
Maintenance and cleaning ...................................................................................................... 10
What to do if... ............................................................................................................................ 10
For the sake of the environment........................................................................................... 10
Spares ............................................................................................................................................. 10
Guarantee ......................................................................................................................................11
Dear Customer
Please read these operating instructions carefully. Pay particular attention to the safety information! Please keep the operating instructions for future reference. Pass them on to any future owner of the appliance.
Before you start
Check the voltage
First check the voltage shown on the data plate (see rear view) to make sure that the cleaner is of the correct voltage for your electricity supply. If it is not, do not use the cleaner but refer back to your dealer.
Connecting to your electricity supply
Permanently connected to the cleaner is a mains supply (2-core) cable fitted with a non-rewirable plug incorporating a 13A fuse. In the event of the fuse requiting replacement the fuse cover should be removed using a small screwdriver. The old fuse MUST be replaced by a 13A ASTA approved BS1362 fuse or a BSI approved fuse. The cover must be replaced before the plug is used again. In the event of loss of the fuse cover, replacements can be obtained from your Electrolux Retailers and must be of the same colour as indicated by the coloured insert on the base of the plug. If difficulty is experienced in obtaining a replacement, contact Electrolux on 08706
055055.
In no circumstances must the plug be used without a correct fuse cover fitted.
If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted. Remove the fuse from the cut off plug. The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13 amp socket in another part of your home.
2
The wires in the mains cable of this appliance are coloured in accordance with the following code: Blue: Neutral. Brown: Live. As the colours of the wires in the mains cable of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as fol­lows: The wire which is coloured blue must be connected to the terminal which is mar­ked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is mar­ked with the letter L or coloured red. If using a three-pin plug, do not make any connection to the terminal marked with the letter E or by the earth symbol or coloured green or green-and-yellow. This cle­aner is double insulated and no earth connection is necessary. It is in your interest to ensure that the plug is correctly attached to the mains cable. In case of doubt, have it done by a qualified electrician, as Electrolux cannot regard the repair of faults on the plug connection as a service that can be given free of charge under the terms of the guarantee.
Fuse cover
Fuse
blue
Cord clamp
N
13 Amp Fuse
E
L
brown
3
Safety information
Power supply: AC only 220/230 V, fuse 13A (see also „Before you start“, page 2).
Do not put the unit into service if: – the connecting lead is damaged, – the unit is visibly damaged.
Use only in the home for cleaning dry material. People and animals must not be treated with the unit. Keep children away from electrical appliances.
Do not vacuum:
Liquids. Allow damp cleaned fitted carpet to dry out completely. Matchsticks, glowing ash or cigarette ends. – Hard, pointed objects. – Toner dust (from laser printers, photocopiers).
Never pull the mains plug from the socket with the cord. Do not run over the mains cable with the unit and suction brush.
Do not clean unit with water (except filters and dust collector as per the instructions).
Do not expose the unit to the effects of weather, moisture or sources of heat.
Dust collector or a paper dust bag and all filters must always be fitted. If no
dust collector or paper dust bag is fitted, the dust-collector compartment cover cannot be closed. Please do not use force!
Repairs to electrical appliances must be carried out by qualified service engi­neers. Improperly performed repairs can result in considerable danger for the user.
If the power cable is defective the entire cable roller must be exchanged by the AEG customer service or an authorised workshop.
The manufacturer accepts no liability for any damage caused by improper use or incorrect operation.
In the event of a fault please contact your specialist dealer or the Electrolux custo­mer service directly.
This vacuum cleaner complies with the following EU Directives
73/23/EEC of 19.02.1973 – Low Voltage Directive.
89/336/EEC of 03.05.1989 (including revised Directive 92/31/EEC) – EMC Directive.
4
Loading...
+ 8 hidden pages