Electrolux EPWD15SS User Manual
27”
(68.5 cm)
26.5”
(67 cm)
42.5”
(108 cm)
Installation Instructions
Electrolux 15” Pedestal
15”
(38 cm)
KIT COMPONENTS:
2 Front brackets.A
2 Rear brackets.B
A
COMPOSANTS DU NÉCESSAIRE :
2 supports avant.A
2 supports arrière.B
B
PIEZAS DEL KIT:
2 soportes delanteros.A
2 soportes traseros.B
SCREW KIT COMPONENTS:
14 #10 (16 x .500) screws.C
COMPOSANTS DU NÉCESSAIRE DE VIS:
14 vis n° 10 (16 x .500).C
C
PIEZAS DEL KIT (TORNILLOS):
14 tornillos n.º 10 (16 x .500).C
IMPORTANT
Total weight IN closed drawer or combination of IN and ON TOP
OF open drawer should not exceed 65 lb. (29.5 kg).
Instructions d’installation
Socle de 38 cm (15 po) Electrolux
Instrucciones de Instalación
Pedestal Electrolux de 15" (38,1 cm)
Tools needed:
Outils nécessaires:
Herramientas necesarias:
OR
O
OU
Universal wrench
supplied with washer
Llave universal propor-
cionada con la lavadora
Clé iniverselle fournie
avec la laveuse
Adjustable wrench
Llave ajustable
Clé à molette
WARNING
Failure to disconnect from power •
source before stacking could result in
personal injury or even death.
Improper installation of dryer venting •
could result in personal injury or
damage to property.
To avoid back or other injury, have more •
than one person move or lift the washer
or dryer.
Do not stack a dryer on top of washer •
already installed on pedestal.
IMPORTANT
Le poids total DANS un tiroir fermé ou une combinaison du poids
DANS et SUR le tiroir ouvert ne doit pas excéder 29,5 kg (65 lb).
IMPORTANTE
137360500 A (1102)
OR
O
OU
9/16” or 14 mm box wrench
Llave de cubo de
9/16 po o 14 mm
Clé polygonale de
9/16 po ou de 14 mm
El peso total DENTRO del cajón cerrado o el peso combinado de
los artículos que estén DENTRO y ENCIMA del cajón abierto no
debe exceder las 65 lb (29,5 kg)
AND
Y
ET
AVERTISSEMENT
Ne pas débrancher l’appareil de sa •
source d’alimentation en électricité
avant de le superposer peut causer des
blessures, voire la mort.
Une installation inappropriée du •
système de ventilation de la sécheuse
peut causer des blessures ou des
dommages matériels.
Pour éviter les blessures au dos ou •
d’autres types de blessure, demandez
l’aide d’autres personnes pour déplacer
ou soulever la laveuse ou la sécheuse
Ne superposez pas une sécheuse sur •
une laveuse déjà installée sur un socle.
.
AND
Y
Phillips screwdriver
Destornillador Phillips
Tournevis Phillips
ET
ADVERTENCIA
El no desconectar el suministro •
eléctrico antes de la instalación apilada
puede ocasionar lesiones personales o
incluso la muerte.
La instalación inadecuada de la •
ventilación de la secadora puede
ocasionar lesiones personales o daños
a la propiedad.
Para evitar lesiones en la espalda u •
otro tipo de lesiones, procure levantar
o mover la lavadora o secadora con la
.
ayuda de más de una persona.
No apile la secadora sobre la lavadora •
si ya está instalada sobre un pedestal.
Carpenter’s level
Nivel de carpintero
Niveau de charpentier
English continued on page 2.
Pour la suite de la version française,
reportez-vous à la page 5. La versión en español continúa en la página 8.
Prepare appliance for mounting
NOTE
Due to higher center of gravity of appliance on pedestals, some
side-to-side rocking is normal during operation. Vibration can be
minimized by assuring appliance is installed properly, including being
level and solid on all four (4) legs by following these directions.
If washer or dryer is new and has not been installed yet, skip 1.
to step 4.
If dryer is already installed, disconnect dryer from electrical 2.
and gas connections and exhaust venting. On models with
Steam Option, turn off cold water supply and disconnect water supply hose to dryer.
If washer is already installed, disconnect washer from electri-3.
cal connection. Turn off hot and cold water supply and disconnect hot and cold water supply hoses from water supply
outlets. Disconnect drain hose from drain pipe.
Protect fl oor and unit with cardboard or rug and carefully lay 4.
the appliance on its side and screw each leg completely into
the base.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move
or lift the appliance.
IMPORTANT
DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer on its side.
Serious damage could occur to your washer.
IMPORTANT
If feet are not completely screwed in, mounting holes in
appliance will not align to mounting holes in brackets.
Prepare pedestal before mounting
Locate pedestal 1.
to within a few
inches of its
fi nal location.
DO NOT remove foam!
NOTE
Allow for approximately 5 in. (12.5 cm) behind the pedestal
for clearance of back of washer or dryer to the wall. Allow an
additional 3/4 in. (2 cm) for water inlet on Steam Model Dryers
and additional space if venting dryer upward or downward.
Level the pedestal 2.
front-to-back and
side-to-side by adjusting each leveling
leg. Keep leg extension to a minimum.
Rock the pedestal from corner-to-corner to check for stability. 3.
Repeat leveling and rocking until all four (4) feet are sturdy on
the fl oor and pedestal is level.
Without turning the rubber foot, lock each pedestal leg in 4.
place by tightening its lock nut tight against the pedestal
base.
lock nut
raise
adjustable
pliers
lower
2
Attach front mounting brackets
Attach each front bracket to outer-1.
most set of holes with 2 screws.
Front brackets
from kit.
Attach rear mounting brackets
Each rear bracket has tabs marked “A” and “B”.•
TAB B
TAB A
Each pedestal has slots in the rear marked “1”, “2” •
and “3”.
SLOT 1
SLOT 2
DRAWER
Determine your appliance type (washer or dryer) according to column 1.
1 in table below.
Orient rear brackets according to column 2 for your particular model.2.
Attach each bracket with 2 screws through the holes that line up on 3.
pedestal.
1 - Appliance 2 - Rear bracket orientation
DRYER
Tab A into•
Slot 1•
Arrow pointing to back•
WASHER
Tab A into•
Slot 1•
Arrow pointing to front•
SLOT 3
Each rear bracket also has 2 arrows indicating •
bracket direction when mounted on the pedestal.
DIRECTION
INDICATOR
ARROWS
3
Attach pedestal to appliance
Turn pedestal on its side to match orientation to appliance.1.
Slide pedestal up to appliance and line up holes in mounting 2.
brackets with holes in appliance base.
Attach rear and front brackets to appliance base with supplied 3.
screws into aligning holes - one in each front bracket and two in
each rear bracket.
Using more than one person, carefully return appliance and ped-4.
estal to upright position.
CAUTION
EXCESSIVE WEIGHT HAZARD
To avoid back or other injury, have more than one person move
or lift the appliance.
After retuning appliance upright, loosen each mounting screw 5.
going into appliance base. Allow the appliance to settle in the
brackets and retighten each mounting screw.
WASHER:
DRYER:
IMPORTANT
DO NOT use open dispenser drawer of washer or dispenser
cavity as hand-hold location when tipping washer upright.
Serious damage could occur to your washer.
Installing or re-installing appliance
Washer on pedestal: Dryer on pedestal:
Slide washer/pedestal into place.1.
Check for levelness and rock all four (4) legs again. Repeat 2.
until level and solid.
Refer to Wa3. sher Installation Instructions for complete details
on installing water, drain, or electrical.
Slide dryer/pedestal into place.1.
Check for levelness and rock all four (4) legs again. Repeat 2.
until level and solid.
Refer to 3. Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
4
Loading...