Please read these operating instructions carefully.
Pay particular attention to the section “Safety information” on the first
few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance.
The following symbols are used in the text:
Safety instructions
1
Warning: Information concerning your personal safety.
Important: Information on how to avoid damaging the appliance.
Information and practical tips
3
Environmental information
2
1. These numbers indicate step by step how to use the appliance.
2. ...
3. ...
Printed on environmentally friendly paper.
Thinking ecologically means acting ecologically ...
The safety aspects of this appliance comply with accepted technical
standards and the German Appliance Safety Law. However, as manufacturers we also believe it is our responsibility to familiarise you with the
following safety instructions.
Electrical Safety
• The installation and connection of the new appliance must only be
carried out by qualified personnel.
• Repairs to the appliance are only to be carried out by approved service engineers. Repairs carried out by inexperienced persons may cause
injury or serious malfunctioning. If your appliance needs repairing,
please contact your local AEG Service Force Centre.
Please follow these instructions, otherwise the warranty will not cover
3
any damage that may occur.
• Flush-mounted appliances may only be operated following installation in suitable installation cabinets and workplaces which conform
to the relevant standards. This ensures sufficient protection against
contact for electrical units as required by the VDE [Association of
German Electrical Engineers].
• If your appliance malfunctions or if fractures, cracks or splits appear:
– switch off all cooking zones,
– disconnect the hob from the electricity supply.
Child Safety
The cooking zones will become hot when you cook. Therefore, always
keep small children away from the appliance.
Safety During Use
• This appliance may only be used for normal cooking and frying in the
home. It is not designed for commercial or industrial purposes.
• Do not use the hob to heat the room.
• Take care when plugging electric appliances into mains sockets near
the hob. Connection leads must not come into contact with the hot
surface.
5
Operating Instructions
• Overheated fats and oils catch fire quickly. You should supervise
cooking when preparing foods in fat or oil (e.g. chips).
• Switch off the cooking zones after use.
Safety When Cleaning
• For safety reasons do not clean the appliance with a steam jet or high
pressure cleaner.
• Clean the hob in accordance with the maintenance and cleaning instructions in this manual.
How to avoid damage to the appliance
• Do not use the cooking area as a worktop or storage space.
• The frameless edge of the glass ceramic surface is susceptible to
knocks. Please be careful when moving pots and pans around.
• Do not have the cook zones on with empty pans, or with no pots or
pans on them.
• Ceramic glass is very tough, and impervious to sharp temperature
changes, but is not unbreakable. It can be damaged if particularly
hard or sharp objects fall on to it.
• Do not use pots made of cast iron, or which have damaged bases with
rough edges or burrs. Moving these around may cause scratches.
• If sugar or a mixture containing sugar falls onto a hot cooking zone
and melts, remove immediately, while still hot, using a kitchen
scraper. If left to cool down, it may damage the surface when removed.
• Keep objects or materials liable to melt away from the ceramic glass
surface, for example, artificial materials, aluminium foil, or cooking
wraps. If any other materials or foodstuffs are melting on the ceramic
glass surface, these should also be cleaned away immediately , using a
kitchen scraper.
6
Operating Instructions
2 Disposal
Disposing of the Packaging Material
• All parts of the packaging can be fully recycled; foil and expanded
polyurethane parts are appropriately identified. Please dispose of
packaging material and, if appropriate, your old appliance properly.
• Please follow the national and regional regulations and material
identification (material separation, refuse collection, waste disposal
sites).
Information on disposal
• The appliance must not be disposed of with household rubbish.
• You can obtain information about collection dates or public refuse
disposal sites from your local refuse department or council.
• Warning! Before disposing of old appliances make them inoperable.
Remove the mains lead.
7
Operating Instructions
The Key Features of Your Appliance
• Ceramic glass cooking surface: The appliance has a ceramic glass
cooking surface and 4 rapid response cooking zones. The particularly
powerful radiant heater elements significantly shorten the amount of
time taken for the zones to heat up.
• Sensor fields: Your appliance is operated using TOUCH CONTROL
sensor fields.
• Cleaning: The advantage of the ceramic glass cooking surface and
the sensor fields is their accessibility for cleaning. The flat surface is
easy to clean (see section: “Cleaning and Care”)
• On/Off sensor field: In addition to the sensor field “On/Off” switch,
the appliance has a separate mains switch with which the mains supply to the appliance can be completely switched on and off with one
touch.
• Stop+Go sensor field: Touching this sensor field changes all cooking
zones currently in use to the ”keep warm“ function: touching the
field again restores the zones to their former settings. This function
can be useful in certain situations, for example if you are suddenly
called away from the cooker.
• Displays: Digital displays show information about selected heat set-
tings, functions activated and any possible residual heat in the appropriate cooking zone.
• Safety cut-out: A safety cut-out ensures that all cooking zones
switch off automatically after a period of time if the setting has not
been changed.
• Keep Warm:
• Residual heat indicator: An h for residual heat is shown in the dis-
play if the cooking zone becomes so hot that there is a risk of burning.
• Multipurpose cooking zone: The hob is equipped with a multipur-
pose/casserole cooking zone. Depending on the setting, it can be used
as a round or oval cooking zone, e.g. for oval casseroles or for keeping
dishes or food warm.
• Three-size cooking ring: The hob features a triple-ring cooking
zone. This zone can be set to different sizes, for example to fit smaller
pots. This will save power.
• Timer: All rings can be automatically switched off using the inte-
grated timer. When the end of the cooking time has been reached,
the cooking zone switches off.
V this setting is used for keeping food warm.
8
Description of the hob
Operating Instructions
Single ring cooking zone
1200W
Triple ring cooking zone
2300W
Casserole zone indicator
Control panel
Booster button
Casserole zone
2400W
Single ring cooking zone
1200W
”Timer“ with control display
”Stop+Go“
button
Triple ring
indicator
Cooking zone selection with
displays for heat setting/residual heat
Heat setting
selector
Mains button
On/Off
9
Operating Instructions
Digital Display
The four display fields correspond to the four cooking zones, and give
the following indications:
– ”-“, when switched on, and when switched off automatically by the
safety function,
– ”0.“, when a cooking zone is selected,
– ”v“, when the Keep Warm setting is selected,
– ”1.“ to “9.“, depending on the selected Cook setting,
– ”A“ ,when Automatic Warm Up is on,
– ”H“, when Residual Heat is on,
– ”F“, if there is a fault.
Cooking Zone Safety Cut-out
1
If one of the cooking zones is not switched off after a certain time or if
the heat setting is not changed, the corresponding cooking zone
switches itself off automatically.
h appears in the ring display for all rings that were switched on, and
j after they have cooled down.
The rings are switched off at:
• Heat setting1 - 2after 6 hours
• Heat setting3 - 4after 5 hours
• Heat setting5after 4 hours
• Heat setting6 - 9after 1.5 hours
10
If one or more cooking zones switch off before the times indicated see
3
section “What to do if …”.
Cancelling the Safety Cut-out
To cancel the activated safety cut-out the appliance must be switched
off and then on again using the ON/OFF
cooking zones are again ready for use.
n sensor field. After this the
Switching Off for Other Reasons
Liquids that boil over onto the control panel cause all cooking zones to
switch off immediately.
If you place a wet cloth on the control panel it has the same effect. In
both cases the appliance has to be switched on again using the mains
switch
n after removing the liquid or cloth.
Operating Instructions
Before using for the first time
Initial Cleaning
Wipe the ceramic glass surface with a damp cloth.
Important: Do not use any caustic, abrasive cleaners! The surface could
1
be damaged.
11
Operating Instructions
Operating the hob
When a cooking zone is switched on, it may hum briefly. This is a char-
3
acteristic of all glass ceramic cooking zones and does not impair either
the function or the life of the appliance.
TOUCH CONTROL sensor field.
To operate the TOUCH CONTROL sensor field place your finger from
above flat onto the required field until the appropriate displays come
on or go out or the required function is carried out.
Switching on the Appliance
The entire appliance is switched on using the “On/Off” n sensor field.
Touch the “On/Off” sensor field for approx. 2 seconds.
The digital displays will show j and the decimal point will flash.
12
Once the “On/Off” sensor field has been operated to switch on the ap-
3
pliance, one of the cooking zones must be selected within approx.
10 seconds using the cooking zone selection buttons. Otherwise the appliance switches off again for safety reasons.
Operating Instructions
Switching Off the Appliance
To switch off the appliance completely activate the “On/Off” n
sensor field.
Touch the “On/Off” sensor field for approx. 1 second.
When an individual cooking zone or the entire hob is switched off, any
3
residual heat is shown with an h (for “Hot”) in the digital display for
the appropriate cooking zones.
Cooking Zone Selection
To select the required cooking zone touch the corresponding sensor
field for approx. one second.
A zero with a decimal point will light up in the appropriate cooking
zone display window =.
The decimal point indicates that settings may only be made for this
3
cooking zone.
13
Operating Instructions
Heat Setting Selection + and -
For setting and adjusting the heat setting (V to 9.) for the selected
cooking zone.
Use sensor field + to increase the heat setting.
Lower the heat setting with sensor field -.
If several cooking zones are being used simultaneously, the required
3
cooking zone must be selected by touching the appropriate sensor field
before adjusting the heat setting. The decimal point in the display
shows which cooking zone has been selected.
Keep Warm
The ”keep warm“ function V can be used with all four cooking zones.
1. Select the desired cooking zone using the sensor fields.
2. Using the + sensor field, select the ”keep warm“
V setting.
14
The ”keep warm“ setting is limited to 60 minutes, i.e. after this time the
3
cooking zone is finally switched off.
Loading...
+ 30 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.