Electrolux B 99852G User Manual

B 99852G

User Manual

Hob

Important Safety Information

You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 350350

Installation

z This appliance must be installed and serviced by a competent person as stated in the

Gas Safety ( Installation and Use) Regulations Current Editions and the IEE Wiring Regulations.

z For appliances installed in the Republic of Ireland please refer to NSAI-Domestic Gas

Installations I.S.813 Current Editions and the ETCI Rules for Electrical Installations.

z Remove all packaging before using the hob. z Ensure that the gas and electrical supply complies with the type stated on the rating

plate, located near the gas supply pipe.

z Do not attempt to modify the hob in any way.

Child Safety

z This hob is designed to be operated by adults. Do not allow children to play near or

with the hob.

z The hob gets hot when it is in use. Children should be kept away until it has cooled. z Children can also injure themselves by pulling pans or pots off the hob.

During Use

z This hob is intended for domestic cooking only. It is not designed for commercial or

z This appliance is not connected to a combustion products evacuation device. It must

z When in use a gas cooking hob will produce heat and moisture in the room in which

z When using the hob for a long period of time, the ventilation should be improved, by

z Do not use this hob if it is in contact with water. Do not operate the hob with wet hands.

industrial purposes.

be installed and connected in accordance with current installation regulations. Particular attention shall be given to the relevant requirements regarding ventilation.

it has been installed. Ensure there is a continuous air supply , keeping air vents in good condition or installing a cooker hood with a venting hose.

opening a window or increasing the extractor speed.

z Ensure the control knobs are in the ‘OFF’ position when not in use. z When using other electrical appliances, ensure the cable does not come into contact

with the hot surfaces of the cooking appliance.

z Unstable or misshapen pans should not be used on the hob as unstable pans can

cause an accident by tipping or spillage.

z Never leave the hob unattended when cooking with oil and fats. z Never use plastic or aluminium foil dishes on the hob. z Perishable food, plastic items and areosols may be affected by heat and should not

be stored above or below the hob unit.

Service

z This hob should only be repaired or serviced by an authorised Service Engineer

and only genuine approved spare parts should be used.

Environmental Information

z After installation, please dispose of the packaging with due regard to safety and the

environment.

z When disposing of an old appliance, make it unusable, by cutting off the cable. z The symbol on the product or on its packaging indicates that this product may

not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.

Keep this instruction book for future reference and ensure it is passed on to any new owner.

These instructions are only valid for countries whose identification symbols are shown on the cover of this instruction booklet and on the appliance itself.

Contents

Instructions for the User

Important Safety Information 2 Description of the Hob 5 Operation 6 Maintenance and Cleaning 7 Something Not Working? 9 Service and Spare Parts 10 Customer Care 10 Guarantee Conditions 11

Instructions for the Installer

Important safety requirements 13 Installation 14 Building In 15 Electrical connections 18 Wiring diagram 19 Fault Finding 20 Commissioning 23 Conversion from Natural Gas to LPG 24

Guide to Use the instructions

The following symbols will be found in the text to guide you throughout the Instructions:

Safety Instructions Step by step instructions for an operation

))

)

))

Hints and Tips Environmental Information

This appliance is manufactured according to the following EEC directives: 73/23 EEC - 90/683 EEC - 93/68 EEC 89/336 EEC - 90/396 EEC, current edition.

Description of the Hob

1. Hob T op

2. Semi-rapid Burners

3. Auxiliary Burner

4. Ultra-rapid Burner (triple crown)

5. Control knobs

INSTALLATION

Any gas installation must be carried out by a competent person, and in accordance with existing rules and regulations.

The relevant instructions are to be found in the second section of this manual. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the

event of a breakdown.

WHEN THE HOB IS FIRST INSTALLED

Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory .

Operation

Hob burners

T o light a burner:

))

)

))

z Push in the relevant control knob and turn it to maximum position. z Upon ignition, keep the knob pushed down about 5 seconds. This will allow the

"thermocouple" (fig. 1 - letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.

z Then adjust the flame as required. z If the burner does not ignite, turn the control knob to zero, and try again.

Each control knob is equipped with a pilot light which gradually lights up according to the heat level that you select with the control knob. When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

T o ensure maximum burner efficiency , you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).

Burner minimum maximum

diameter diameter

Large (ultra-rapid) 180 mm 260 mm Medium (semi-rapid) 120 mm 220 mm Small (Auxiliary) 80 mm 160 mm

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.

If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.

Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.

If the control knobs become difficult to turn, please contact your local Service Force Centre.

A - Burner cap B - Burner crown C - Ignition electrode D - Thermocouple

Fig. 1

Using the Wok Stand

A wok stand is provided to enable you to use a round bottomed wok on the hob. The wok stand must only be used on the central burner, and should not be used with any other type of wok or pan. When fitting the wok stand, ensure the recessesd in the frame fit securely onto the bars of the pan supports, as shown in figure 2.

Fig. 2

Maintenance and Cleaning

Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply .

The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.

The Hob Top

Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little wasing up liquid has been added. Avoid the use of the following:

- household detergent and bleaches;

- impregnated pads unsuitable for nonstick saucepans;

- steel wool pads;

- bath/sink stain removers. Should the hob top become heavily soiled, the following product s are recommended:

- for stainless steel hobs use a proprietary stainless steel cleaner;

- for other hobs use Hob Brite or Bar Keepers Friend.

If scratches or cracks are noticed, disconnect the appliance from the electrical supply and call your nearest Service Force Centre.

YES

fig. 3.

Pan Supports

T o keep the pan supports in the correct position, they are mounted on metal pins located in the back of the hob. After cleaning the hob, ensure the pan supports are properly placed as shown in fig. 3. The pan supports are dishwasher proof. If washing them by hand, take care when drying them as the enamelling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner.

The Burners

The burner caps and crowns can be removed for cleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove. After cleaning, be sure to wipe dry with a soft cloth.

Ignition electrode

The electric ignition is obtained through a ceramic "electrode" and a metal electrode (fig. 1 - letter C). Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes are not obstructed.

Something Not Working?

If the hob is not working correctly , please carry out the following checks before contacting your local Service Force Centre.

SYMPTOM

 There is no spark when lighting the gas

SOLUTION

 Check that the unit is plugged in and the

electrical supply is switched on

 Check that the RCCB has not tripped (if fitted)  Check the mains fuse has not blown  Check the burner cap and crown have been

replaced correctly, e.g. after cleaning.

 The gas ring burns unevenly

 Check the main jet is not blocked and the

burner crown is clear of food particles.

 Check the burner cap and crown have been

replaced correctly, e.g. after cleaning.

If after all these checks, your hob still does not operate correctly , contact your local Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any inguarantee service calls.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

+ 19 hidden pages