Eldes EKB3 User Manual

LED KEYPAD

EKB3

User Manual v1.4

Compatible with:

• ESIM264 v07.14.02 and up.

• ESIM364 v02.06.01 and up.

Main features:

• Alarm system arming & disarming;

• Stay mode activation & deactivation;

• System parameter conguration;

• PGM output control;

• Visual indication by LED indicators;

• Audio indication by built-in buzzer;

• Keypad partition switch.

EKB3 is a LED keypad intended to use with ELDES alarm systems. The system conguration by EKB3 keypad is performed by ac­tivating the Conguration Mode and entering the required parameters & values. ELDES alarm systems allow to connect up to 4
EKB3 keypads.

NOTE: For complete system conguration & control using EKB3 keypad, please refer to ELDES alarm system installation manual
located at: www.eldes.lt/en/download

1. Package content

1. EKB3 ............................................ qty. 1

2. User manual ............................ qty. 1

3. 5,6kΩ resistor .......................... qty. 1

2

2. Technical specications

2.1 Electrical and mechanical characteristics

Power supply 12-14V 150mA max

Maximum keypad connection cable length 100 m.

Dimensions 140x100x18mm

Range of Operating Temperatures -30...+55ºC

2.2 LED Functionality

ARMED Steady ON - alarm system is armed / exit delay in progress; ashing - Conguration mode activated

READY Steady ON - system is ready – no violated zones and tampers

SYSTEM Steady ON - system faults; ashing - violated high-numbered zones

BYPS Steady ON - zone bypass mode

1-12 Steady ON - violated zone

2.3 Keys Functionality

[BYPS] Zone bypass mode

[CODE] System fault list / violated high-numbered zone indication / violated tamper indication

[*] 1st character for Conguration mode activation/deactivation command (for ESIM364 up to v02.06.20 and ESIM264 all

[#] Conrm (enter) command

[0] ... [9] Command typing

[1] ... [4] Keypad partition switch (only for ESIM364) / steady ON - armed partition indication (only for ESIM364) / ashing - vio-

[0] Simultaneous 4-partition arming (only for ESIM364)

[STAY]

[INST] 1st character for Conguration mode activation/deactivation command (only for ESIM364 v02.07.00 and up)

versions) / clear typed in characters / keypad partition switch (if enabled; only for ESIM264)

lated partition indication (only for ESIM364)

Manual system arming in Stay mode

2.4 Connector functionality

AUX+ Positive 12-14V power supply terminal

AUX- Negative 12-14V

G RS485 interface for communication (green wire)

Y RS485 interface for communication (yellow wire)

COM Common terminal for Z1

Z1 Security zone terminal

Z2 N/A

A B

ARMED

READY

SYSTEM BYPS

7

1

8

2

9

3

10

4

11

5

12

6

USER MANUAL EKB3 V1.4 3

power supply terminal

FRONT SIDE

1 2 3

4 5 6

7

8 9

0 #

*

Fig. No. 1

STAY

BYPS

INST

CODE

BACK SIDE

3 2

DIP SWITCH

Fig. No. 2

TAMPER

COM Y

Z2 Z1

AUX-

G

AUX+