EKWB EK-Quantum Momentum Aorus X570 Master D-RGB – Plexi User Manual

EKQuantum
Momentum Aorus X570 Master D-RGB – Plexi

MONOBLOCK

USER GUIDE

This product is intended for installation only by expert users.
Please consult with a qualified technician for installation. Improper
installa tion may result in damage to your equ ipment. EK Water Blocks
assumes no liability whatsoever, expressed or implied, for the use of
these products, nor their installation. The following instructions are
subject to change without notice. Please visit our web site at www.
ekwb.com for updates. Before installation of this product please
read important notice, disclosure and warranty conditions printed
on the back of the box.

Before you start using this product please follow these basic guidelines:

Please carefully read the manual thoroughly before beginning
with the installation process!

Please remove your motherboard from the computer to assure
safest mounting process in order to prevent any possible
damages to your CPU and/or motherboard’s circuit board (PCB).

The EK- Fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured by the
rubber o-ring gaskets.

The use of quality, market proved corrosion inhibiting coolants
is always strongly recommended for any liquid cooling system.

TABLE OF CONTENT

PREPARING YOUR MOTHERBOARD 4

REMOVING FACTORY PROVIDED BACKPLATE 4
REMOVING STOCK COOLER 4
REMOVING OF THE ORIGINAL PL ASTIC HOLDDOWN AND THE FACTORY BACKPLATE 5
APPLYING THERMAL COMPOUND 6
CUTTING THERMAL PADS 6
PLACING THERMAL PADS ON THE MOTHERBOARD 6

PLACING THE BLOCK ON TO MOTHERBOARD 7

ATTACHING BLOCK ON THE MOTHERBOARD 7
CONNECTING THE DRGB LED STRIP 8

REQUIRED TOOLS 9
SUPPORT AND SERVICE 10
SOCIAL MEDIA 10

- 3 -