EKWB EK-Quantum Kinetic TBE D5 PWM Service Manual

EK-Quantum
Kinetic TBE D5 PWM

PUMP & RESERVOIR COMBO

INSTALLATION MANUAL

ASSEMBLING THE PUMP
(already done by EK)

EK-Quantum Kinetic TBE D5

60x3 O-ring Gasket

Locking Ring

EK-D5 PWM G2 Motor

Pump Holder

- 2 -

Rubber
Damper

Screws M3x12

STEP 1

Install the EK-Quantum Kinetic TBE D5 onto the EK-D5
PWM G2 Motor. Make sure you install the provided 60x3
O-ring gasket. Reseat the gasket if needed. You can
rotate the EK-D5 PWM G2 Motor if required.

STEP 2

Secure the EK-D5 PWM G2 Motor on the EK-Quantum
Kinetic TBE D5 using enclosed Locking Ring.

- 3 -

ALTERNATIVE DAMPER

Pyramids must be facing UP

STEP 1

- 4 -

STEP 1

An alternative soft rubber damper is included. If
excessive pump vibrations are transmitted through the
mounting assembly then this can be used to reduce
them further. When replacing the damper, take care that
the pyramids face upwards as shown. Use of the soft
damper is only recommended when the unit is installed
vertically.

- 5 -

USING EK-HD TUBE

- 6 -

STEP 1