EKWB EK-Quantum Inertia D5 PWM Installation manual

EK-Quantum
Inertia D5 PWM

PUMP

INSTALLATION MANUAL

This product is intended for installation by expert users only.
Please consult with a qualified technician for installation.
Improper installation may result in damage to the equipment.
EK Water Blocks assumes no liability whatsoever, expressed
or implied, for the use of these products, nor their installation.
The following instructions are subject to change without
notice. Pleas e visit our website at w ww.ekwb.com for update s.

Before you start using this product, please follow the basic
guidelines:

Carefully read the manual before beginning with the
installation process!

BOX CONTENT

EK-Quantum
Inertia D5 PWM D-RGB

EK Fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured with
the rubber o-ring gaskets.

The use of quality market-proven corrosion-inhibiting
coolants is always strongly recommended for any liquid
cooling system.

- 2 - - 3 -

MOUNTING MECHANISM
Bag content is universal; you may not need every screw.

Allen Key 2 mm (1 pc)

Allen Key 2.5 mm (1 pc)

MOUNTING MECHANISM
Bag content is universal; you may not need every screw.

INSTALLING THE PUMP

M3 x 12 DIN7984 (2 pcs) M4 x 10 DIN7984 (5 pcs)

M4 PVC Washers (5 pcs) Protective Sticker (1 pc)

- 4 - - 5 -

(ALREADY DONE BY EK)

EK-Quantum Inertia

60x3 O-ring Gasket

EK-D5 PWM G2 Motor

Locking Ring

Rubber Damper

Pump Holder

M3 x 12 DIN7984

Install the EK-D5 PWM G2 Motor onto the EK-

64

34

Quantum Inertia by following these steps:

1. Install the provided 60x3 O-ring gasket to the EK-D5
PWM G2 Motor.

2. Once the O-ring gasket is in place, take the pump and
place it into the EK-Quantum Inertia. You can rotate
the EK-D5 PWM G2 Motor if required.

3. Fix the pump onto the EK-Quantum Inertia using the
locking ring.

4. Take the rubber damper and place it into the pump holder.

5. Once the rubber damper is installed into the pump

holder, push the assembled part onto the EK-D5
PWM G2 Motor.

6. Take the M3x12 DIN7984 screws and secure the E K­D5 PWM G2 Motor to the pump holder. You should

use the 2mm Allen Key. The plate with two M3 thread
holes is preinstalled by EK.

- 6 - - 7 -

INSTALLING EK-QUANTUM
INERTIA D5 PWM D-RGB

By default, the EK-Quantum Inertia D5 PWM D-RGB
ships with a pump holder that can be installed directly
to the computer chassis. If there are no appropriate
mounting holes available, the user may need to drill
four (4) Ф5 mm holes through the metal chassis with an
electric power drill. Included is a sticker that can be

used to mark the hole centers accurately.