EKWB EK-Pro GPU WB RTX 4000 – Ni + Inox Installation manual

EK-Pro
GPU WB RTX 4000 – Ni + Inox

GPU WATER BLOCK

INSTALLATION MANUAL

This produc t is compatible wit h Nvidia Quadro RTX 4 000 graphic s card.
It is intended for installation by exper t users only. Please consult with a
qualified technician since improper installation may result in damage
to the equipment. EK assumes no liability whatsoever, expressed
or implied, for the use of these products, nor their installation. The
following instructions are subject to change without notice. Please visit
our website at www.ekwb.com for updates. Before the installation of
this product, please read important notice, disclosure, and warranty
conditions printed on the back of the box.

Before you s tart using this prod uct, please follow t hese basic guidelines:

Carefully read the manual before beginning with the
installation process.

Remove your graphics card from the computer for the safest
mounting process and to prevent any possible damages to your
GPU or its circuit board (PCB).

EK Fittings require only a small amount of force to screw them
firmly in place since the liquid seal is ensured with the rubber
O-ring gaskets.

The use of quality market-proven corrosion-inhibiting coolants
is always strongly recommended for any liquid cooling system.

Do not use pure distilled water as a cooling liquid! For best
results, EK recommends the use of EK-CryoFuel Coolants.

- 2 -

TABLE OF CONTENTS

PREPARING THE GRAPHICS CARD 4

REMO VING THE STOCK C OOLER 4
CLE ANING THE P CB 4
APPLYING THERMAL COMPOUND 5
CUTTING THERMAL PADS 5
PL ACIN G THER MA L PADS O N PCB 5

INSTALLING THE WATER BLOCK 6

PL ACIN G THE BL OCK ON T HE GR AP HICS C ARD 6
ATTACH ING THE BLOCK T O THE GR A PHIC S CA RD 7
CHECK ING FO R CONTACT 8
INSTALL ATIO N OF FI TT INGS A ND TUBING 8
INSERTING THE GR A PHIC S CA RD IN TH E PC CA SE 9

REQUIRED TOOLS 9
SUPPORT AND SERVICE 10
SOCIAL MEDIA 10

- 3 -