EKWB EK-Pro GPU WB RTX 2080 Ti – Ni + Inox Installation manual

EK-Pro
GPU WB RTX 2080 Ti – Ni + Inox

GPU WATER BLOCK

INSTALLATION MANUAL

This product is compatible with Nvidia Quadro RTX 2080 Ti graphics
card. It is intended for installation by expert users only. Please consult
with a qualified technician since improper installation may result
in damage to the equipment. EK assumes no liability whatsoever,
expressed or implied, for the use of these products, nor their installation.
The following instructions are subject to change without notice. Please
visit our website at www.ekwb.com for updates. Before the installation
of this product, please read important notice, disclosure, and warranty
conditions printed on the back of the box.

Before you s tart using this prod uct, please follow t hese basic guidelines:

Carefully read the manual before beginning with the
installation process.

Remove your graphics card from the computer for the safest
mounting process and to prevent any possible damages to your
GPU or its circuit board (PCB).

EK Fittings require only a small amount of force to screw them
firmly in place since the liquid seal is ensured with the rubber
O-ring gaskets.

The use of quality market-proven corrosion-inhibiting coolants
is always strongly recommended for any liquid cooling system.

Do not use pure distilled water as a cooling liquid! For best
results, EK recommends the use of EK-CryoFuel Coolants.

- 2 -

TABLE OF CONTENTS

PREPARING THE GRAPHICS CARD 4

REMO VING THE STOCK C OOLER 4
CLE ANING THE P CB 4
APPLYING THERMAL COMPOUND 5
CUTTING THERMAL PADS 5
PL ACIN G THER MA L PADS O N PCB 5

INSTALLING THE WATER BLOCK 6

PL ACIN G THE BL OCK ON T HE GR AP HICS C ARD 6
ATTACH ING THE BLOCK T O THE GR A PHIC S CA RD 7
CHECK ING FO R CONTACT 8
INSTALL ATIO N OF FI TT INGS A ND TUBING 8
INSERTING THE GR A PHIC S CA RD IN TH E PC CA SE 9

REQUIRED TOOLS 9
SUPPORT AND SERVICE 10
SOCIAL MEDIA 10

- 3 -