Remote control 12
Setting up the remote control 12
Notes 12
Caution 13
Remote control functions 13
Regulating airflow direction 15
Manual drainage 16
Drain parts 16
Draining with the drain tray 16
Direct drainage 17
Maintenance 17
Notes 17
Cleaning the Exterior 17
Cleaning the condenser coils 17
Prefilter and charcoal filter 17
Notes 17
Installing the charcoal filter 18
Cleaning the prefilter 18
Long term storage 18
Troubleshooting 19
Limited warranty 22
1
Thank you
Thank you for purchasing an EdgeStar portable air conditioner. Rest assured that all
EdgeStar products are designed and manufactured to the highest standards. We would
like you to be able to fully utilize all features of this portable air conditioner, so
please take the time to read this owner’s manual in full prior to using the unit.
Energy saving tips:
1. Use the portable air conditioner for the recommended room size. Rooms that are
too small can cause the unit to short cycle and work inefficiently. Rooms that are
too large will never cool completely.
2. Be careful not to obstruct the air flow coming out of the portable air conditioner.
A powerful, unobstructed airflow is crucial for optimum cooling.
3. Keep blinds and curtains closed during the sunniest part of the day.
4. Clean the pre-filter often, and replace the activated carbon filter as needed (it
should be replaced twice a year under normal conditions).
5. Close your fireplace damper, floor grills, and wall grills to prevent cool air from
escaping.
6. Avoid opening doors frequently
7. Note that each additional person in room adds between 100-150 BTU of heat, so
the more people in a room, the more cooling capacity is required
8. Set the portable air conditioner to maximum cooling and high speed airflow when
you first start it up, and then adjust the unit to a comfortable setting.
Notes:
The portable air conditioner must be plugged into an appropriate power outlet. Refer
to the rating label on the back of the unit for more information.
The portable air conditioner is a compressor-driven cooling system. The air
conditioner has an anti-overheating safety feature that can delay the compressor from
starting for three minutes after the air conditioner turns on or when a mode change is
made. If the compressor does not immediately start, it is likely because of this feature.
To protect the compressor from overheating or freezing, it will only operate when the
ambient temperature is between 61° and 97°F.
Always unwind the power cord completely before use.
Please note that in Cooling, Heating, Auto, and Dry modes, the exhaust hose must be
used.
The heating function is equipped with an auto-defrost function. When using the
heating function, heating may be interrupted briefly to melt any accumulated frost.
Heating will begin again once the frost is melted.
When switching into the Cooling mode or Heating mode, cooling or heating may be
temporarily delayed as the unit cools down / heats up.
2
Specifications
Model AP410HS
Maximum Room Size (cooling)* 400 ft²
Maximum Room Size (heating)* 400 ft²
Power consumption for cooling mode 1150W
Power consumption for heating mode 1050W
Air flow 212 ft³/m
Humidity removal capacity 2.11 p/h
Noise level <54 dbA
Power supply 120V/ 60Hz
Compressor Rotary
Refrigerant R-22 or R-470C
Refrigerant Load 450g
Timer 1-12 hours
Thermostat 61°-88°F
Net weight 71 pounds
Dimensions 29 1/4"h x 15"w x 14 3/4"d
Box dimensions 29 15/16"h x 21"w x 17 3/8"d
*Please note that maximum room sizes are under ideal conditions. Actual
cooling/heating areas may vary
Safety precautions:
1. Transport the portable air conditioner in an upright position only. If the unit is
tipped over, make sure it stands upright for at least 3 hours prior to turning it on.
2. Always place the unit on a level surface.
3. In order to cool, the hot air from the exhaust port in the rear of the portable air
conditioner must be exhausted outside the room.
4. Make sure the portable air conditioner is connected to a grounded power outlet.
5. This portable air conditioner is designed to operate in an ambient temperature of
61°-97° F.
3
6. This portable air conditioner has been designed for residential use.
7. Always turn the portable air conditioner off before unplugging it.
8. Do not damage the power cord.
9. Do not use this portable air conditioner for functions other than those described in
this owner’s manual.
10. Do not tilt the portable air conditioner.
11. Do not cover or obstruct the intake or outlet grills.
12. Do not use the portable air conditioner in a wet room- such as a bathroom or
laundry room- to avoid the possibility of shock.
13. Do not bend or crush the exhaust hose while in use.
14. Do not sit on, or place articles on, the portable air conditioner.
15. Do not touch the portable air conditioner with wet or damp hands
16. Do not let chemical substances come into contact with the portable air
conditioner.
17. Do not use the portable air conditioner in the presence of flammable substances or
vapors such as alcohol, insecticides, gas, etc.
18. Do not use the plug to start or stop the unit.
19. Do not yank on the electric cord or place it near a source of heat. If the electric
cord is damaged, it must be replaced by an authorized service agent.
20. Always use the control panel to start or stop the portable air conditioner.
21. Always allow for air flow around the portable air conditioner of at least 20”.
22. Always turn off the portable air conditioner when not in use.
23. Always turn the portable air conditioner off and unplug it after use, before
cleaning, before carrying out maintenance, and before moving it.
24. It the electrical socket is different from the plug, have a professionally qualified
electrician replace the socket with a suitable one. Do not use adapter plugs,
multiple sockets, or extension cords.
25. The filter must be used at all times. When removing the filter for cleaning, turn
off the unit and unplug it.
26. Make sure all children are properly supervised around this portable air
conditioner.
4
Parts
Front view
1. Control panel
2. Adjustable louvers
3. Carry handles
4. Caster wheels
Rear view
1. Air inlet
2. Exhaust port
3. Power cord hooks
4. Caster wheels
5. Drain plug (a plastic drain cap covers a rubber stopper)
5
Accessories
Drain hose
Exhaust hose
Drain tray
Rectangular vent
connector
Carbon filter
Owner’s manual and
warranty card
Round adapter
Cap for round
adapter
Remote and batteries
Plastic window kit
and screws
6
Installation
Installing the exhaust hose
In order to be used effectively, the exhaust hose must be mounted to the back of the
unit.
1. Make sure the rectangular vent connector is fitted to one end of the exhaust hose
and fit the round adapter to the other end.
2. Insert the rectangular vent connector into the exhaust port on the back of the unit.
7
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.