Edge Lighting Sloped Ceiling Standoffs User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MS-SL-_

904-MS-SL-02

Installation Instructions for

Monorail Sloped Ceiling Standoffs

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- The product is intended to be used with Edge Lighting
Monorail systems only.

- Use Monorail standoffs where the Monorail sections join
together and approximately every 3 feet max throughout
the Monorail run.

SAVE THESE INSTRUCTIONS!

Install the Standoff Hardware

A

2

CEILING

3

1: Hold the Monorail section against the ceiling or use a plumb

bob to mark the sloped standoff locations onto the ceiling
(this may require more than one person).

2: Tap the anchors onto the marked locations up to the
threaded portion with a hammer.

3: Screw the threaded portion of the anchors in with a Phillips
screwdriver.

ANCHOR

4: Mount the integrated washer-nipple to the anchor with the
#8 screw provided.

5: Tighten the threaded post completely onto the integrated
washer-nipple.

Sloped Standoff Connector

Installation for Monorail Power Feed

Canopies

C

1.5MM ALLEN
WRENCH

1

M3 SET SCREW

THREADED
POST

SLOPED STANDOFF
CONNECTOR

B

4

1: Push the sloped standoff connector completely into the

threaded post and tighten the M3 set screw with the 1.5mm
Allen wrench.

ANCHOR

#8 SCREW

INTEGRATED
WASHER-NIPPLE

5

THREADED POST

1

Sloped Standoff Connector Surface TransformerInstallation for

D

THREADED
POST

JOINING ROD

1

1.5MM ALLEN
WRENCH

M3 SET SCREW

1: See the chart below to determine the joining rod size.

2: Push the joining rod completely into the threaded post and

tighten the M3 set screw with the 1.5mm Allen wrench.

Transformer Type

150 Watt

300 Watt

600 Watt

Model Number

MT-150- 3"

MT-300- 3.4"

MT-600- 3.7"

Joining Rod Size

E

M3 SET SCREW

1.5MM ALLEN
WRENCH

3: Push the joining post half way onto the other end of the
joining rod and tighten the M3 set with the 1.5mm set
screw.

F

JOINING POST

M3 SET SCREW

1.5MM ALLEN
WRENCH

4

SLOPED STANDOFF
CONNECTOR

4: Push the sloped standoff connector completely into the
joining post and tighten the M3 set screw with the 1.5mm
Allen wrench.

Install the Monorail to Rigid Standoff

G

SLOPED CONNECTOR

3

JOINING POST

4

THREADED POST

1: Tighten the rigid standoff completely onto the sloped
connector threaded post.

STANDOFF

2