Edge Lighting Scope LED Pendant User Manual
© 2011 Edge Lighting. All Rights Reserved.
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
FJ-SCLP-_
Installation Instructions for Fast Jack Scope LED Pendant
IMPORTANT INFORMATION
- This product is ETL listed for indoor dry locations.
- The product is intended to be used with Edge Lighting
Monorail systems only.
- The product is safe to be used in food processing or
consuming areas without the glass lens. It is safe to use
the thermoplastic lens in the fixture. For more information
see "Adjusting the Light Beam" section.
SAVE THESE INSTRUCTIONS!
Adjust the Fixture Height
904-FJ-SCLP-05
A
H
1
2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.
3: Remove the M3 set screw on tip of the connector with the
1.5mm Allen wrench provided.
1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the metal shade to the end of the coaxial cable.
B
2MM ALLEN
WRENCH
M4 SET SCREW
2
COAXIAL FIXTURE CONNECTOR
3
1.5MM ALLEN
WRENCH
M3 SET
SCREW
C
5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.
CONICAL
NIPPLE
STRAIN RELIEF TUBE
4
COAXIAL CABLE
4: Feed the coaxial cable through the conical nipple and flared
side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.
D
COAXIAL CABLE
5
1
E
1.5MM ALLEN WRENCH
6: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip. The
outer metal jacket will start to wrinkle.
M3 SET SCREW
WRINKLE
8
OUTER METAL JACK
9: Push the strain relief tube completely into the coaxial
fixture connector. Make sure the slot on the strain relief
tube is not inline with the M4 set screw.
10: Tighten the M4 set screw with the 2mm Allen wrench.
INNER WIRE
G
11
7: Hold the fixture connector in place. Replace and tighten the
M3 set screw on fixture connector tip with the 1.5mm Allen
wrench.
8: Pull down the outer metal jacket to smooth the wrinkles.
7
6
F
2MM ALLEN WRENCH
COAXIAL FIXTURE
CONNECTOR
M4 SET SCREW
STRAIN RELIEF TUBE
11: Use fingers to tighten the Fast Jack fixture connector into
the Fast Jack system connector (Monorail, Monorail 2
Circuit, or canopy connector - Refer to the instructions
provided with the system connector or canopy).
10
9
11
11
11
CIRCUIT #1
11
12
12: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose Circuit #1 or Circuit #2.
11
CIRCUIT #2
1
2
N
12
1
2
N
2
Loading...