Edge Lighting S5, S7 User Manual
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
© 2010 Edge Lighting. All Rights Reserved.
info@edgelighting.com
Installation Instructions for Large Solid Back Shade MR16
IMPORTANT INFORMATION
- This product is ETL listed for indoor dry locations.
SAVE THESE INSTRUCTIONS!
Install the Louver Lens Holder (Optional)
S5-_
904-S5-04
A
2
MR16 LAMP
3: Press the tabs on the sides of the louver lens holder against
the MR16 lamp to keep it in the position.
HEXCELL LOUVER
AND/OR GLASS LENS
TAB
1
LOUVER LENS
HOLDER
1: Place the Hexcell louver (Optional) or glass lens (Optional)
or a combination of a hexcell and glass lens into the louver
lens holder.
2: Place the MR16 lamp into the louver lens holder.
B
TAB
3
Install the Accessory Shade in Low Rider Type Fixtures
C
MR16 LAMP
1: Place the MR16 lamp into the accessory shade and line up
the MR16 lamp pins with the socket holes.
SLOTTED
SHADE HOLDER
2
ACCESSORY SHADE
2: Push the lamp pins completely into the socket holes and
3
simultaneously push the accessory shade onto the slotted
shade holder.
3: The accessory shade must fit snugly onto the slotted shade
holder. If adjustment is necessary, carefully bend the slotted
shade holder tabs slightly in or out with needle-nose pliers.
NOTE: The provided spring clip is not used in this installation.
1
Loading...