Edge Lighting Round Adjustable Power Feed Canopies User Manual

904-MP-4RD-A-04

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MP-4RD-A-_

Installation Instructions for Monorail 4" Round Single Power Feed Canopy

With 12' Adjustable Power Feed Wires

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.

- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).

- This product should be installed by a qualified electrician.

SAVE THESE INSTRUCTIONS!

Install the Canopy

A

POWER CORD

PLASTIC DISK

NOTE: Use the universal round crossbar (provided) if the electrical

box holes are not spaced 2-3/4" apart.

NOTE: The low voltage wires should be present in the electrical

box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.

4

2MM ALLEN WRENCH

3

2

1

M4 SET SCREW

1: Loosen the two M4 set screws on the plastic disk with the
2mm Allen wrench provided.

2: Adjust the power feed wires to the desired height (from top
of the canopy to top of the Monorail - illustrated as "H" in
diagram A) by pushing the power feed wires into the canopy.

3: Tighten the two M4 set screws firmly with the 2mm Allen
wrench.

4: Leave at least 6" of the power feed wires behind the canopy.
Trim off the excess power feed wires with a sharp cutter.

H

B

6

6

5: Turn the power to electrical box off.

6: Strip 1/4" of insulation off of the power feed wires and

connect each low voltage wire coming from the remote
transformer to one power feed wire with a wire nut.

1

C

7: Place all wires inside the electrical box.

8: Secure the power feed canopy to the electrical box by

tightening the two provided #8-32 screws with the 3/32
Allen wrench.

#8-32
SCREW

3/32 ALLEN
WRENCH

1: Unscrew the cap from power housing.

2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE THEM

8

8

E

MONORAIL

3

POWER HOUSING

Install the Power Feed Canopy
Wires to Monorail

D

POWER HOUSING

1

CAP

2

3: Place the Monorail into the power housing. Make sure that

the Monorail is supported by the standoffs. Refer to the
instructions provided with the standoffs.

4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.

3/8-24 SET SCREW

3/16 ALLEN WRENCH

4

CAP

5: Tighten the 3/8-24 set screw on the cap firmly with the 3/16
Allen wrench for proper power connection.

G

7

PLASTIC DISK

M4 SET SCREW

2MM ALLEN WRENCH

6

F

CAP

3/8-24 SET SCREW

3/16 ALLEN WRENCH

6: If the power feed wires are sagging, loosen the two M4 set
screws on the plastic disk with the 2 mm Allen wrench.

7: Push the power feed wires into the canopy and tighten the
two M4 set screws with the 2mm Allen wrench.

5

2