Edge Lighting Regal User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

REGAL-H1-_

M2-IND-_

Installation Instructions for Regal (Halogen Version)

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.

- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.

- It is normal for a new halogen lamp to produce minor
smoke when first turned on.

- Turn power off and allow to cool before replacing lamp.

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product is wall mounted only.

- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.

- This product can be dimmed with a standard incandescent
dimmer.

SAVE THESE INSTRUCTIONS!

904-REGAL-H1-01

Install the Fixture

A

1

COVER

2: Squeeze the spring ends and remove them from the inner
bracket.

3: Pull the reflector out.

FIXTURE BODY

1

THUMB SCREW

Remove the two thumb screws on the sides of the fixture

1:
body to detach the cover.

B

2

3

FIXTURE

SPRING CLIP

INNER
BRACKET

SPRING
CLIP

REFLECTOR

3

1

C

LOCK WASHER

4

CROSSBAR
ASSEMBLY

4: Loosen and remove the two hex nuts and lock washers from
the center of fixture body to remove the crossbar assembly.

D

CROSSBAR ASSEMBLY

HEX NUT

5:

Feed the power wires through the crossbar assembly center

hole.

6: Mount the crossbar o the electrical box holes with
the provided two #8-32 screws.

assembly t

E

8

9

FIXTURE BODY

7

6

#8-32 SCREW

7: Make sure that the fixture is grounded in accordance with
local electrical codes.

8: Connect the white fixture wire to the neutral power wire with
a wire nut.

9: Connect the black fixture wire to the hot power wire with a
wire nut.

F

FIXTURE BODY

HEX NUT

6

5

ELECTRICAL BOX HOLE

10: Secure the fixture body to the crossbar assembly by
tightening the hex nuts and lock washers.

G

SOCKET

11

11

LAMP

10

10

LOCK WASHER

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

NOTE: Use only fingers and a soft cloth to install the lamp.

Use MAX 75 Watt Type T3-78mm, Double
End Halogen Lamp For Each Socket.

11: Place one end of the lamp onto one socket pin, while
pushing the lamp against that socket pin slide the other
end onto the other socket pin. Repeat this step for the
other socket.

2