Edge Lighting Quattro LED User Manual

© 2012 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJ-QUA-12-SN

Installation Instructions for Fast Jack Quattro LED Pendant

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- The product is intended to be used with Edge Lighting
Monorail systems only.

SAVE THESE INSTRUCTIONS!

Adjust the Fixture Height

904-FJ-QUA-01

A

2: Loosen the M4 set screw on base of the coaxial fixture
connector with the 2mm Allen wrench provided. Do not
remove this set screw.

3: Remove the M3 set screw on tip of the connector with the

1.5mm Allen wrench provided.

COAXIAL CABLE

1

H

METAL SHADE

1: Cut the coaxial cable to the desired height (H) with a sharp
cutter. The overall fixture height is measured from the
bottom of the metal shade to the end of the coaxial cable.

B

2MM ALLEN
WRENCH

M4 SET SCREW

2

COAXIAL FIXTURE CONNECTOR

3

1.5MM ALLEN
WRENCH

M3 SET
SCREW

C

CONICAL NIPPLE

5: Feed the coaxial cable into the coaxial fixture connector. The
coaxial cable will come to a stop point.

STRAIN RELIEF TUBE

4

COAXIAL CABLE

4: Feed the coaxial cable through the conical nipple and flared
side of the strain relief tube. Slide the conical nipple and
strain relief tube down the coaxial cable.

D

5

COAXIAL CABLE

1

E

1.5MM ALLEN WRENCH

6: Keep feeding the coaxial cable in until the inner wire is
visible in the screw hole of the fixture connector tip. The
outer metal jacket will start to wrinkle.

M3 SET SCREW

WRINKLE

8

OUTER METAL JACK INNER WIRE

9: Push the strain relief tube completely into the coaxial
fixture connector. Make sure the slot on the strain relief
tube is not inline with the M4 set screw.

10: Tighten the M4 set screw with the 2mm Allen wrench.

7: Hold the fixture connector in place. Replace and tighten the

M3 set screw on fixture connector tip with the 1.5mm Allen
wrench.

8: Pull down the outer metal jacket to smooth the wrinkles.

7

6

F

2MM ALLEN WRENCH

M4 SET SCREW

STRAIN RELIEF TUBE

COAXIAL FIXTURE
CONNECTOR

10

9

G

11

11

11

CIRCUIT #1

11

12

11: Use fingers to tighten the Fast Jack fixture connector into

the Fast Jack system connector (Monorail, Monorail 2

11

11

Circuit, or canopy connector - Refer to the instructions
provided with the system connector or canopy).

12: Refer to the instructions provided with the Monorail 2
Circuit fixture connector to choose Circuit #1 or Circuit #2.

NOTE: The Quattro LED head consumes 6 watts and contains

integrated LED lamps which are rated for 50,000 hours.

CIRCUIT #2

1
2
N

12

1
2
N

2