Edge Lighting Puck LED User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2012 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Puck LED

IMPORTANT INFORMATION

- This product can be installed as recessed or surface
mount.

- It is recommended to use the HUB-4P or HUB-8P to power
the Puck Lights.

- This product works with a 12 Volt AC LED electronic
transformer (TE-60L-12) & is dimmable with a low voltage
electronic dimmer.

- This installation instruction shows typical installation.

SAVE THESE INSTRUCTIONS!

Recessed Mount Installation

PUCK-RD-3W-90D-30K-SA

904-PUCK-04

A

MOUNTING
RING

1

FIXTURE

3

2.5"

(6.35cm)

4

LED PUCK

SURFACE

1: Remove the mounting ring.
2: Use the mounting ring as a template to mark the screw

location where the LED Puck light is going to be installed.

3: Use a 1/16" drill bit to drill pilot holes on marked locations.
4: Feed the LED Puck wires through the mounting ring. Hold

the cord against the notch on the mounting ring while
installing the mounting ring to the pilot holes with the
provided two Phillips screws.

5: Pull the cord through the notch on the mounting clip and
snap the LED puck light into the mounting ring.

6: Repeat the steps 1 through 5 for the remaining pucks and
then follow the "Power the Puck Lights" steps.

5

NOTE: Omit the steps below if surface mounting the Puck Lights.

1: Remove the mounting ring and discard it.
2: Mark the location where the LED Puck light is going to be

recessed.

3: Drill out the marked location with a 2.5" circular saw.
4: Feed the LED Puck light wires through the cut out hole and

snap the LED Puck light into the hole.
5: Repeat the steps 1 through 4 for the remaining pucks and

then follow the "Power the Puck Lights" steps.

Surface Mount Installation

B

MOUNTING
RING

1

FIXTURE

NOTCH

4

4

PHILLIPS
SCREW

LED PUCK

6

5

SURFACE

1

Power the Puck Lights

C

POWER
SUPPLY

AC POWER CORD

LED PUCK AC CORD

4

PHILLIPS
SCREW

6

HUB

7

1: Mark the location where the hub is going to be installed.
2: Use a 1/16" drill bit to drill pilot holes on marked locations.

5

3: Mount the hub to the pilot holes with the three Phillips

screws provided.

3

3

HUB

CORD

4: Connect the AC Power cord into the single port of the hub.
5: Connect each LED Puck AC cord into one port.
6: Use the provided clips to manage the Pucks and Hub cords.
7: Connect the Hub AC power cord to the 12 volt power supply

CLIP

wires. Refer to the instructions provided with the power
supply.

NOTE:

Each Puck contains three 1 watt LEDs consuming a total

of 3 watts.

TYPICAL WIRING DIAGRAM

ELECTRONIC LOW VOLTAGE

DIMMER OR SWITCH

BLACK (HOT)

WHITE(NEUTRAL)

120VAC

RECTANGLE

CANOPY COVER

(3RE-WH)

RECTANGLE

ELECTRICAL BOX

TE-60L-12AC

TE-60L-12AC-3RE-WH

6FT

PUCK LED CABINET LIGHTING. 3W PER FIXTURE
EDGE # PUCK-RD-3W-90D-30K-SA

HUB-4P

8FT

12VAC

2