Edge Lighting Power Feed Canopies User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MP-4RD-1-_

904-MP-4RD-1-03

Installation Instructions for

Monorail 4" Round Single Power Feed Canopy

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.

- Minimum electrical box volume must be 6 cubic inches
(98 cubic centimeters).

- This product should be installed by a qualified electrician.

SAVE THESE INSTRUCTIONS!

Install the Canopy

A

NOTE: Use the universal round crossbar (provided) if the electrical

box holes are not spaced 2-3/4" apart.

NOTE: The low voltage wires should be present in the electrical

box. Refer to the instructions provided with the remote
transformer to install the transformer and the low voltage wires
before proceeding with the steps below.

2

3: Place all wires inside the electrical box.

4: Secure the power feed canopy to the electrical box by

tightening the two provided #8-32 screws with the 3/32
Allen wrench.

2

1: Turn the power to electrical box off.

2: Connect each low voltage wire coming from the remote

transformer to one power feed canopy wire with a wire nut.

B

#8-32
SCREW

3/32 ALLEN
WRENCH

4

4

1

Install the Monorail to Power Feed Canopy

C

POWER HOUSING

1

CAP

2

3: Place the Monorail into the power housing. Make sure that

the Monorail is supported by the standoffs. Refer to the
instructions provided with the standoffs.

4: Tighten the cap to the power housing. Make sure the cap
is not cross threaded.

3/8-24 SET SCREW

3/16 ALLEN WRENCH

1: Unscrew the cap from power housing.

2: Slightly loosen the 3/8-24 set screw on the cap with the
3/16 Allen wrench provided, DO NOT REMOVE IT.

D

POWER HOUSING

3

4

CAP

MONORAIL

E

3/8-24 SET SCREW

5: Tighten the 3/8-24 set screw on the cap firmly with the 3/16
Allen wrench provided for proper power connection.

CAP

5

3/16 ALLEN WRENCH

2