Edge Lighting Port LED Components User Manual

© 2011 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

SC-WO

Installation Instructions for Sun 3 & Port Spring Clips

IMPORTANT INFORMATION

- The Spring Clips (SC-WO) are an accessory that are used
with Sun3 and Port fixtures. When they are installed in a
porch wood surface.

SAVE THESE INSTRUCTIONS!

Install the Spring Clips

904-SC-WO-01

A

PHILLIPS SCREW

FIXTURE
TRIM TAB

SPRING CLIP

FIXTURE

TURN SPRING CLIPS

TOWARD EACH
OTHER BEFORE
INSTALLATION

NOTE:

For outdoor installation, use UL listed type UF

underground cables and outdoor rated wire nuts when no conduit

SPRING CLIP

2

2

MOUNTING HOLE
IDENTIFICATION

PORT HOLE

SUN3 HOLE

2

is used to power the fixture(s).

1: Remove the two Phillip screws from the bottom of the
fixture trim tab.

The inner hole on spring clip is to be used with Port and

NOTE:

the outer hole is to be used with Sun3 fixture.

For each spring clip, align one of the two holes (refer to

2:

diagram for clarification) with the trim tab hole. Replace and
tighten the Phillips screw. Before installing fixture,

slightly rotate the spring clips towards each other to
make it easier to install (refer to the drawing).

Installation Preparations

B

2

1: Mark a point on the surface where the fixture opening is

going to be located.

2: Cut out the marked location with a 2-7/8" circular saw for
SUN3 or a 2" circular saw for Port fixture.

For detailed wiring information refer to the instructions

NOTE:

provided with each fixture.

Wiring Diagram

120V HOT (BLACK)

120V NEUTRAL (WHITE)

POWER
SUPPLY

FIXTURE

SURFACE

-

+

2 or 2 7/8"
HOLE

700mA

1