Edge Lighting Plaza Large LED - Dimmable User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2014 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Plaza Large LED

IMPORTANT INFORMATION

- This product is wall mounted only.

- Supply power to mirror in accordance with local electrical
codes.

- This instruction shows a typical installation

- This product is dimmable with ELV dimmers.

SAVE THESE INSTRUCTIONS!

Install the Mounting Plate

PLAZA-L-LED-27K

904-PLAZA-L-LED-02

A

MIRROR

MOUNTING
PLATE

M6 SCREW

3: Align the mounting plate hole with the power line conduit, or
junction box. Use the mounting plate as a template to
mark eight mounting holes (highlighted in GREEN) onto the
wall.

NOTE: Make sure that the mounting plate is leveled horizontally.

1

2

NOTE: It is recommended that one person holds the mounting

plate while the electrician installs it.

1: Loosen and remove the four M6 screws on the top and
bottom of the mounting plate with the 3mm Allen wrench.

2: Pull the mounting plate completely out of the mirror.

B

ALIGN
CENTER
WITH
JUNCTION
BOX

MOUNTING
HOLE

3

3

H

4: Tap the anchors onto the marked points up to the threaded

WALL

4

ANCHOR

BE FLUSH TO WALL

5

ANCHOR MUST

portion with a hammer.

5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

1

D

7

8-32 SCREW
(8X)

WALL

MOUNTING
PLATE

6: Feed the 120 VAC power wires through the mounting plate.

7: Line up the mounting plate holes with the anchors and

secure it with the eight #8-32 screws provided.

8: Ensure the mounting plate is grounded in accordance with
local electrical codes.

NOTE: Contains integrated 24V LED lights consuming a total of

110 Watts.

6

120 VAC
POWER
WIRES

9: On the Wago connector that connects the 120V hot
transformer wires, pull up an available lock lever and insert
the 120VAC hot power wire. Press the lock lever down to
connect and lock into place.

10: On the Wago connector that connects the 120V neutral
transformer wires, pull up an available lock lever and insert
the 120VAC neutral power wire. Press the lock lever down
to connect and lock into place.

F

M6 SCREW

12

E

120
VAC
HOT
WIRE

PUSH
DOWN
TO LOCK

9

WAGO
CONNECTORS
(2X)

PSU
HOT
WIRES

PSU
NEUTRAL
WIRES

10

PUSH
DOWN
TO LOCK

120
VAC
NEU
WIRE

11: Carefully place the mirror onto the mounting plate.

12: Secure the mirror to the mounting place by tightening four

M6 screws using an 3mm Allen wrench.

MIRROR

11

MOUNTING
PLATE

2