Edge Lighting Night Owl LED User Manual
© 2011 Edge Lighting. All Rights Reserved.
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
info@edgelighting.com
NIGHTOWL-P-_
Installation Instructions for Night Owl (Plug-In Version)
IMPORTANT INFORMATION
- This product is ETL listed for indoor locations.
- This product is for wall mount application.
- This instruction shows a typical installation.
SAVE THESE INSTRUCTIONS!
Install the Fixture
904-NIGHTOWL-P-02
A
BACKPLATE
1: Remove the cover by sliding it up and then off the backplate.
B
WALL
COVER
1
BACKPLATE
MOUNTING
HOLE
2
2
2: Hold the backplate against the surface where the fixture is
going to be mounted. Level the backplate vertically and mark
the two mounting holes on the surface.
MOUNTING
HOLE
C
ANCHOR
WALL
3
4
NOTE: Omit steps 3 to 5 if installing the fixture onto a surface
other than drywall like bedroom wood board. Use the provided
screws to mount the backplate directly to the wood board.
3: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.
4: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.
5: Mount the backplate to the anchors with the two #8 screws.
E
D
6: Replace and slide the cover down completely onto the
backplate.
WALL
BACKPLATE
#8 SCREW
MOUNTING
HOLE
5
5
COVER
6
BACKPLATE
7: Plug the power supply into the 120 volt power outlet.
NOTE: The fixture contains a 1 Watt integrated LED lamp. This
lamp is rated for 50,000 hours.
8: Use the rocker switch on the bottom of the backplate to
control intensity of the light.
F
7
PLUG-IN
120 VOLT
POWER OUTLET
2
Loading...