Edge Lighting Neo Pro Aim User Manual

© 2009 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

M-NEO-_

M2- -_NEO

FJ- -_NEO

904-NEO-02

Installation Instructions for

Neo Pro-Aim

IMPORTANT SAFETY INSTRUCTIONS

To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:

- Use this fixture indoors only.

- Do not look directly at the lamp while the fixture is on.

- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.

- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.

- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.

- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.

- Do not touch lamp at anytime. Use a soft cloth. Oil from skin
may damage lamp.

- It is normal for a new halogen lamp to produce minor
smoke when first turned on.

- Do not operate the luminaire with a missing or damaged
shield.

- Turn power off and allow to cool before replacing lamp.

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

- This product is not restricted to certain height installation.
It is approved to be used at any height above the floor.

- Applicable accessories are Hexcell Louver, Glass Lenses &
MR16 Snout.

SAVE THESE INSTRUCTIONS!

Install the Lamp & Lens Accessory

A

SHADE

1

FIXTURE BODY

CAUTION: To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

Use MAX 50 Watt IR, Type MR16 Front Glass Cover
Halogen Lamp.

2: Push the lamp pins completely into the socket holes.

1: Loosen and remove the shade completely out of the fixture

body.

B

SOCKET

LAMP

2

1

C

3

Place the lens(es), or a combination of a lens and hexcell

4:

louver into the shade.

5: Replace and tighten the lens holder ring to secure the lenses
in place.

SHADE

SMALL ALLEN
WRENCH

LENS HOLDER RING

3:

From the inside of the shade, use a small Allen wrench or a

pen point to loosen and remove the lens holder ring.

D

4

SHADE

LENS

LENS

LENS HOLDER RING

5

E

SHADE

6

FIXTURE BODY

Install the Neo to the
Monorail (MC-FJ-_)

1: Remove the Monorail housing connector from the Monorail

Fast Jack housing and discard it.

6: Tighten the shade completely to fixture body.

F

MONORAIL FAST
JACK HOUSING

HOUSING
CONNECTOR

(DISCARD)

1

G

MONORAIL FAST
JACK HOUSING

2

MONORAIL

NEO HOUSING
CONNECTOR

2: Place the Monorail Fast Jack housing onto the Monorail and
use fingers to tighten the Neo housing connector to the Fast
Jack housing. Make sure that the Neo housing

connector is not cross threaded.

2

2