Edge Lighting Marilyn Moods RGB User Manual

© 2014 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

MAR-RD-22-RGB-CH

Installation Instructions for Marilyn Moods Round RGB

IMPORTANT INFORMATION

- This product is wall mounted only.

- This instruction shows a typical installation

- The RGB LEDs are controlled by a wireless controller
(included) for light intensity, show & color modes.

SAVE THESE INSTRUCTIONS!

Install the Backplate

904-MARILYN-04

A

MIRROR

PHILLIPS SCREW

1: Remove the two Phillips screws from the sides of the

1

1

BACKPLATE

backplate.

2: Carefully lift the mirror.

B

ELECTRICAL
BOX

BACKPLATE

3

NOTE: It is recommended that one person holds the backplate

while the electrician installs it.

3: Align the backplate center hole with the electrical box. Level
the backplate horizontally and mark the four key holes onto
the wall.

4: Remove the backplate.

BACKPLATE
CENTER HOLE

3

3

3

1

9/32 DRILL BIT

C

WALL

ANCHOR

5: Use a 9/32 drill bit to make holes on all four marked points.

6: Tap the anchors into the drilled holes with a hammer.

5

7: Tighten (not completely) the four #8 screws into the anchors

leaving the head unscrewed for 1/8".

PHILLIPS SCREW

E

6

10

6

BACKPLATE

D

PHILLIPS SCREW

7

8: Feed the power wires coming from the electrical box

through the backplate center hole.

9: Hang the backplate keyholes onto the exposed screws.

10: Tighten the four #8 screws completely to the secure the

backplate in place.

9

11: Make sure that the backplate is grounded in accordance

with local electrical codes.

12: Connect one power supply wire (either one to hot & the
other one to the neutral power lines with wire nuts.

13: Place all wires and wire nuts inside the electrical box.

8

F

POWER
SUPPLY

BACKPLATE

12

2