Edge Lighting Heat Sink Reflector L-Shaped Flat Channel User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2009 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for L Shape Reflector

IMPORTANT INFORMATION

- This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

Install the Reflector

SS-HR-L-_

904-SS-HR-L-01

A

UNDER CABINET

1: Determine the location where the reflector will be installed.

TAPE MEASURE

2: Using a tape measure determine the reflector size.

2

B

REFLECTOR

3

3: Mark the size of the reflector.

4: Cut the excess reflector with a hacksaw.

5: Clean the inside and the outside burrs of the cut sections.

REFLECTOR

4

1

C

REFLECTOR

7

SOFT STRIP LED

NOTE: Avoid bending the soft strip in sharp horizontal angles
which may damage the LEDs. Use the proper power connectors.

6: Clean the area thoroughly on the reflector where the soft
strip LED will be installed.

7: Remove the backing from the soft strip LED and firmly press
down making sure there are no air bubbles that can cause
surface irregularities.

8: Place the reflector on surface and secure with the
provided #6 screws.

NOTE: Use the provided anchors if mounting reflector to other
surfaces like drywall.

D

REFLECTOR

8

#6 SCREW

CABINET

2