Edge Lighting Flexible T-Connector User Manual

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]

www.edgelighting.com

© 2011 Edge Lighting. All Rights Reserved.

[e-mail]

Installation Instructions for Flexible "T" Connector

IMPORTANT INFORMATION

- These products are ETL Listed for indoor locations.

SAVE THESE INSTRUCTIONS!

Installing the Flexible "T" Connector to Soft Strips

SS-CFXT-3IN

904-SS-CFXT-01

A

NOTE: The straight ends of the Flexible "T" connector plug into

male ends of the Soft Strips and the perpendicular end plugs into

FLEXIBLE
T-CONNECTOR

1

FEMALE END OF
THE SOFT STRIP

1

female end of a Soft Strip. Make sure this fits to the design before
Installing the Soft Strips and Flexible "T" connector.

Simply connect the proper side of the Soft Strip to the

1:

Flexible "T" connector. Refer to the installation provided to
the installation instruction provided with the Soft Strip to
complete the installation.

Installing the Flexible "T"

1

1

MALE END OF
THE SOFT STRIP

Connector to Light Channel

B

FLEXIBLE
T-CONNECTOR

3

POWER
END CAP

1

SCREW

NOTE: The straight ends of the Flexible "T" connector plug into

male ends of the Light Channels and the perpendicular end plugs
into female end of a Light Channel. Make sure this fits to the
design before Installing the Light Channels and Flexible "T"
connector.

1: For each Light Channel, remove the bottom two screws of
the end that is going to be connected to the Flexible "T"
connector.

2: Place the Flexible "T" connectors ends into the cord grips
(provided with the Light Channel).

3: Push the each Light Channel onto the one end of the Flexible
"T" connector. Tighten the cord grip to the end of the Light
Channels with the two Phillips screws (provided with the cord
grips).

4: Refer to the installation instructions provided with the Light
Channel to complete installation.

LIGHT CHANNEL
POWER END CAP

3

SCREW

3

FLEXIBLE
T-CONNECTOR

LIGHT CHANNEL

CORD GRIP

CORD GRIP

2

1