Edge Lighting Fast Jack 26 Port Canopies User Manual

904-FJP-24SQ-01

© 2011 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJP-24SQ-_-20W-_

Installation Instructions for 20 or 24 Port Square Fast Jack Canopy

IMPORTANT INFORMATION

- This product is dimmable with a low voltage electronic
dimmer.

- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.

SAVE THESE INSTRUCTIONS!

Install the Canopy

Install the Canopy

A

#8-32 SCREW

1

CANOPY

NOTE: It is recommended that a person to hold the mounting

plate while the electrician installs it.

Feed the power wires through mounting plate center hole.

2:

3:

Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.

C

5

4

MOUNTING PLATE

ANCHOR

1: Remove the sixteen #8-32 screws around the canopy to
remove the mounting plate.

1

B

2

3

4: Tap the anchors through the mounting plate holes onto the

marked point up to the threaded portion with a hammer.

5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

3

#8-32 SCREW

MOUNTING PLATE

MOUNTING PLATE

NOTE: All 8 anchors must be installed to balance the pendants

weight.

1

D

WASHER

6: Secure the mounting plate to the anchors with the provided
#8 screws and washers.

6

#8 SCREW

7: Make sure that the mounting plate is grounded in
accordance with local electrical codes.

NOTE: Make sure a person holds the Fast Jack canopy while the

electrician connects the wires and completes the installation.

8: Connect the Fast Jack white canopy wire to the neutral
power wire with a wire nut.

9: Connect the Fast Jack black canopy wire to the hot power
wire with a wire nut.

F

#8-32 SCREW

10

11

MOUNTING PLATE

MOUNTING PLATE

11

E

9

FAST JACK CANOPY

10: Place all wires and wire nut connections inside the canopy.

11: Place the canopy onto the mounting plate and tighten the

sixteen #8-32 screws.

ELECTRICAL BOX

8

FAST JACK CANOPY

CAUTION: Maximum load of each port is 20 watt. Use

only fixtures that are rated 20 Watt or less, or relamp each

fixture with a Maximum 20 watt lamp.

12:

Use fingers to tighten each Fast Jack fixture connector into

one Fast Jack canopy port.

G

FAST JACK
FIXTURE
CONNECTOR

12

FAST JACK
CANOPY
PORT

2