Edge Lighting Fast Jack 17 Port Canopies Without Transformers User Manual

© 2012 Edge Lighting. All Rights Reserved.

1718 W. Fullerton Ave

Chicago, IL 60614

Tel: [phone]

Fax: [phone]
www.edgelighting.com
[e-mail]

FJC-16RD-_

904-FJC-16RD-01

Installation Instructions for

16" Round 5, 7, & 9 Port Fast Jack

Canopy Only

IMPORTANT INFORMATION

- This product is ETL listed for indoor dry locations.

SAVE THESE INSTRUCTIONS!

Running the Power from a Remote Transformer to the
Fast Jack Canopy

A

ELECTRICAL BOX

1

REMOTE
TRANSFORMER

MAX

20FT

CONDUIT

FAST JACK
CANOPY

1: Run the low voltage wires from a remote transformer to
electrical box where Fast Jack canopy is going to be
installed. It is recommended to install the remote
transformer near the electrical box to avoid voltage drop.
Refer to the instructions provided with remote transformer
for low voltage wire size chart. Refer to the low voltage wire
size chart provided with the remote transformer.

Install the Canopy

1: Loosen and remove the six #8-32 screws around the canopy

to remove the mounting plate.

C

2

3

3

#8-32 SCREW

MOUNTING PLATE

B

#8-32 SCREW

1

CANOPY

Feed the low voltage coming from the remote transformer

2:
through mounting plate center hole.

3:

Align the mounting plate slots with the electrical box holes
and secure it to the electrical box holes with the provided
two #8-32 screws.

MOUNTING PLATE

1

1

D

4: Mark the three mounting plate holes on the ceiling.

4

MOUNTING PLATE

5: Tap the anchors through the mounting plate holes onto the
marked point up to the threaded portion with a hammer.

6: Screw in the threaded portion of the anchors with a Phillips
screwdriver.

F

7

E

5

6

MOUNTING PLATE

7: Secure the mounting plate to the anchors with the provided
#8 screws and washers.

ANCHOR

6

G

WASHER

#8 SCREW

8: Insert one end of the safety cable into the safety bracket of
mounting plate and the other end into the canopy safety
bracket.

7

7

MOUNTING PLATE

SAFETY BRACKET

8

SAFETY
CABLE

MOUNTING
PLATE

CANOPY

2

H

9: Make sure that the mounting plate is grounded in

accordance with local electrical codes.

10: Connect each canopy wire to one low voltage transformer
wire with a wire nut.

10 10

11: Place all wires and wire nut connections inside the canopy.

12: Place the canopy onto the mounting plate and tighten the

six #8-32 screws.

J

FAST JACK
FIXTURE
CONNECTOR

13

FAST JACK
CANOPY
PORT

I

MOUNTING PLATE

12

#8-32 SCREW

CANOPY

CAUTION: Risk of Fire: The total load of the Fast Jack

canopy ports should not exceed the remote transformer rated
capacity.

13:

Use fingers to tighten each Fast Jack fixture connector into

one Fast Jack canopy port.

11

3