EcoxGear GDI-EXEJ300, GDI-EXEJ301 User Manual

Models: GDI-EXEJ300 / 301

User Guide

EcoJam

On/Off

Press the Standby Power Button once to
power ON/OFF.

IMPORTANT: Standby Power function
will NOT operate when the Master
Power is set OFF. Master Power Switch
under the cap on the back panel must
be set ON for Standby & your EcoJam
to operate.

Bluetooth

When turned ON, the EcoJam will power
on and search for your Bluetooth. Refer
to “Set Up Recommendations 1-2-3”
part for details.

Speaker Volume

Press to decrease or to increase
Speaker Volume.

NOTE: Some Bluetooth devices may
require to be manually set for maximum
audio level.

3

Quick Start

Open Cap on the back
of your EcoJam

Turn on the Main Power Switch
Press the Standby Button to

power on your EcoJam
Search your Bluetooth

Connection on your Smart Device
Pair & Play

1

2

3

4

5

Control Buttons

LED Status Indicators

Power, Battery, Bluetooth

Control Buttons & Operations

Set Up
Recommendations 1-2-3

Charge Your EcoJam

Before you power on your EcoJam
for the FIRST TIME, for best
performance, connect the USB Micro
port with a USB cable to a power
source and fully charge your EcoJam.

NOTE: Charge the unit until all 5 LED
battery level indicators are solid blue,
indicating a full charge.

Approximately 3 hours of charging
time is required from a low to a
full charge.

Power source options include a USB
connection to your computer or a
power outlet using a USB to AC
power adapter. It is recommended to
always use the USB cable included
with your EcoJam.

1

Your EcoJam will beep to indicate when
maximum volume setting is reached.

Track Selection

Press button once to select Previous Song
track & Next Song track .

Play/Pause

Press button once to pause & play song
tracks (MUST be paired with Bluetooth).

Answer

Press button once to answer mobile calls
(MUST be paired with Bluetooth).

Battery Indicator

When connected with a USB cable to a
power source, the LED indicates a USB
connection and charging status.

RED: charge in process
GREEN: full charge complete

NOTE: There also are five LED battery level

indicators located on the top of the unit.
Each LED represents 20% of a charge.
Five full LEDs indicate a full charge.

Bluetooth Pairing & Your Audio

Connecting With Bluetooth: Connect
To Your Smart Device & Play Audio

When your EcoJam is turned on, the
blue LED light on the top panel will
flash rapidly indicating the unit is
ready to pair.

Turn on Bluetooth on your Bluetooth
device (Smart Device) and set the device
in pairing mode. Available Bluetooth
connections shall appear. Select the
ECOXGEAR speaker from the list of
discovered devices on your Bluetooth
device. Wait for a few seconds until the
connection is completed.

NOTE: Bluetooth connection feature
is found in the Settings section of
most mobile phones and other
Bluetooth enabled devices.

When the ECOXGEAR selection is
made and the Bluetooth connection
is completed, your EcoJam will
announce: “Bluetooth connected”

3

Power ON, Battery,
& LED Status Indicators

Once fully charged, press the Standby
Power Button on your EcoJam.
You will see the green LED light & you
will hear an ascending bell tone.

IMPORTANT: Ensure the Main
Power Switch, located in the back
compartment under the cap, is set in
the Upper ON position. If the switch
is in the Lower OFF position, your
EcoJam will not be able to turn on
using the Standby Button.

NOTE: The LED battery level
indicators are located on the top of
the unit. Each LED represents 20% of
a charge, with 5 full LEDs indicating a
full charge.

Audio playback time over Bluetooth
connection is approximately 12 hours
at 75% volume.

2