Power Pruner
Operator's Manual
TM
MODEL:
99946400020 5' EXTENSION
FOR MODELS PP-1200/1250/1260
PPT-2100/2400
PPT-230/231
PPT-260/261
PPT-280
PPT-265
99946400030
5' EXTENSION
FOR MODELS PP-1400
PPFD-2400
PPFD-260
ENGLISH
X7502300600
ESPAÑOL
FRANCAIS
W ARNING DANGER
Read rules for safe operation and instructions carefully. ECHO provides an Operator's
Manual and a Safety Manual with your original Power PrunerTM. Those manuals and this
manual must be read and understood for proper and safe operation.
89865022060
04/07
2
5 FOOT EXTENSION INSTALLA TION
Tools Required: Screwdriver, 3 mm Hex Wrench, Measuring Tape
Parts Required: 1524mm (5 Foot) Extension
W ARNING DANGER
The Saw Chain is sharp! Always wear gloves when handling the
cutting attachment, otherwise serious personal injury may result.
A
D
1 . Loosen the four (4) screws (A), and locator screw (B) on cutting
attachment, and remove the cutting attachment.
(PPT Only)
2 . Loosen clamp knob (C) turning counter clockwise.
3 . Pull aluminum housing (D) out of fiberglass housing 610mm (24 in.),
then slide (D) back into fiberglass housing approximately 305mm
(12 in.) exposing inner drive shaft (E).
(All Models)
4 . Measure 178mm (7 in.) from end of aluminum housing (D), and mark
the housing.
5 . Loosen the extension clamp knob (G) turning counter clockwise.
6 . Align inner drive shaft adapter (E) with extension shaft (F).
NOTE
Assure locator hole in extension shaft is oriented on same side as
locator hole in aluminum housing (D).
7 in.
E
B
C
D
12 in.
D
F
G
7 . Align ridges on aluminum housing (D) with seams in extension
housing. Slide the extension onto housing (D) to the 178mm (7 in.)
mark. Tighten extension clamp knob (G) securely.
D
G
C
D
8 . Align extension drive shaft adapter (H) with cutting attachment
shaft (I).
NOTE
Locator screw in cutting attachment must align with locator hole in
extension housing.
5' EXTENSION ATT ACHMENT
OPERATOR'S MANUAL
3
9 . Align ridges on aluminum extension housing (J) with seams in
cutting attachment and slide cutting attachment onto extension
housing. Remove locator screw (B) to align locating hole in cutting
attachment with locating hole (L) in aluminum extension housing.
10. Install and tighten locator screw (B). Tighten four (4) cutting
attachment screws (A).
J
H
J
A
J
I
B
L
W ARNING DANGER
• The Power PrunerTM is designed to accept only one extension. Use of more than one extension or longer shafts
can result in balance and control problems leading to possible personal injury to operator and bystanders and/or
unit damage.
• Use this extension with ECHO Power PrunerTM models ONLY.
ECHO CONSUMER PRODUCT SUPPORT
If you require assistance or have questions concerning the application, operation or maintenance of this product you may
call the ECHO Consumer Product Support Department at 1-800-673-1558 from 8:30 am to 4:30 pm (Central Standard Time)
Monday through Friday. Before calling, please know the model and serial number of your unit to help your Consumer
Product Support Representative.
ECHO, Incorporated 400 Oakwood Road Lake Zurich, IL 60047
www.echo-usa.com
Loading...