Earthway C22HDS User Manual
ASSEMBLY and OPERA TING INSTRUCTIONS
EarthWay
EV-N-SPRED
®
C22HD & C22HDS
Broadcast Spre ader
PLEASE CALL IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS REGARDING
THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
S
UPPORT HOT LINE: 574-848-7491 or 800-294-0671 EMAIL: support@earthway.com
HELPFUL HINTS:
If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after
each use. Wash between the shut off plate and bottom of the hopper.
Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
When using Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt will
reconstitute back into a solid block over night with humidity and will damage your spreader.
1. Remove and identify all of the loose parts from carton.
ROCK SALT IS NOT RECOMMENDED
FOR USE IN THIS SPREADER.
REMOVE AGITATOR WHEN USING
CE MELT.
I
2. Position hopper on side. Install frame using (4) #14x 1-1/2” Flat
Head Phillips machine screws.
Pt# 52153 PAGE 1
3. Install impeller onto pinion shaft. Insert 1/8” x 1-1/4” cotter pin
through impeller then through pinion shaft. Use hole nearest gear box.
Spread cotter pin to prevent from falling out. Next, install the Cross Brace
through the Gearbox Brace as shown above.
5. Install Lower Handles onto Axle to both
sides as shown above. Now insert 1-1/2” bolt
through first hole in lower handle, then
through frame brace, and finally into the
threaded connector in the Cross Brace.
[NOTE: Dimples on frame braces must be
facing toward gearbox as shown.]
DO NOT TIGHTEN YET.
Next insert 1-1/2” bolt through other end of
frame brace and through second hole in frame
install locknut.
DO NOT TIGHTEN YET.
Now insert 2-1/4” bolt through second hole in
lower handle and through first hole in fra me.
4. Install Gearbox by inserting the pinion shaft into hole in center
of hoppers bottom. The word “FRONT” on the gearbox must
point to F
RONT of the hopper.
NOW GO BACK AND TIGHTEN ALL NUTS AND BO LTS STARTING WITH FIRST STEP. DO NOT OVE R TIGHTEN.
PAGE 2
Loading...