Earlex Pro-Steam LCS150NA, SteamMaster LMB 150NA Operating Instructions Manual
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USE
Thank you for purchasing an Earlex Steam Wallpaper Stripper.
In order to obtain the best results please read the instructions before
commencing any work. Please also make a special note of the safety rules.
UNDER NO CIRCUMSTANCES SHOULD THIS PRODUCT BE USED FOR ANY
PURPOSES OTHER THAN THOSE DETAILED HEREIN AND EARLEX Inc WILL
ACCEPT NO RESPONSIBILITY FOR SUCH USE.
RETAIN FOR FUTURE REFERENCE
US Patent No. 5,542,021 U.K. Patent No. 2,263,966
VEUILLEZ LIRE ATTENTIVEMENT LES INSTRUCTIONS CI-DESSOUS AVANT
D’UTILISER LA DECOLLEUSE
Nous vous remercions d’avoir fait l’acquisition d’une décolleuse à vapeur Earlex. Afin
d’obtenir les meilleurs résultats, il est conseillé de lire les instructions suivantes avant
de commencer le travail. Faites particulièrement attention aux règles de sécurité.
N’UTILISEZ EN AUCUN CAS CET APPAREIL POUR DES TRAVAUX AUTRES QUE
CEUX QUI SONT
DECRITS DANS LA PRESENTE NOTICE. LA SOCIETE EARLEX
DECLINE TOUTE RESPONSIBILITE POUR LES USAGES INAPPROPRIES DE SON
PRODUIT.
CONSERVEZ CETTE NOTICE A TOUTES FINS DE REFERENCE FUTURE
Brevet USA 5,542,021 Brevet UK 2,263,966
OPERATING INSTRUCTIONS FOR
LMB 150NA
LCS150NA
NOTICE D’INSTRUCTIONS POUR
LMB 150NA
LCS150NA
PS0176 0507 21/5/08 4:03 pm Page 1
l Keep away from children and animals.
l Do not pull by the mains lead or the
steam hose.
l Be careful of overhead dripping, when
using on overhead areas tilt the steam
plate away from the face and body, and
regularly empty the steam plate of any
collected condensation.
l Do not leave unattended.
l Do not point the steam plate at anyone.
l Do not allow water or steam to enter
light switches or sockets.
l Always use and store upright. Always
empty unit after use.
l Always visually check that the hose and
steam plate inlet are not blocked before
attempting to use.
l Fully uncoil mains cable and hose before
commencing use.
l Do not strain, kink or trap the hose
under heavy objects.
l
Use only 4lb pressure cap as supplied.
It is also a safety valve.
NEVER BLOCK OFF THIS OUTLET.
l NEVER remove the filler cap when unit
is boiling - switch off and wait for 5 minutes.
l Always disconnect power supply when
filling the machine or when not in use.
l Do not use any caustic cleaners on the tank.
l Do not allow to boil dry.
l Do not overfill the reservoir. DO NOT
USE ADDITIVES.
l Never detach the hose whilst the unit is
switched on.
l The tank becomes hot in use. Do not touch.
Only move with the carrying frame.
l Steam is produced at 100˚C. Wear
protective clothing and gloves when
operating this stripper.
l DO NOT USE THIS STRIPPER FOR
ANY OTHER PURPOSES THAN
DETAILED IN THESE INSTRUCTIONS
l Under no cirumstances should you
attempt to repair a unit unless qualified
and authorised to do so. Use only genuine
Earlex replacement parts.
l If unit is exposed to excessive heat, as
in the case of fire, it should be removed
from service and destroyed due to loss
of structural strength.
l Before using, check all parts for proper
function and damage to component
parts. Do not use a damaged or improperly
functioning stand/frame.
l Use a ground fault circuit interrupter (GFCI) to
protect yourself against electric shock.
l This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance by
a person responsible for their safety.
WARNING
l
Power cord must be connected to grounded
(3 prong) outlet.
l
Replace a worn or damaged power cord.
Never repair a power cord.
l
Removal of grounding pin VOIDS warranty
Extension Leads
If you are using an extension lead it must be
rated at a minimum of 15 amps and fully
unwound. Do not operate with a lead rated at
less than 15 amps as this will cause premature
failure of the element which is not covered by
the guarantee.
Technical Specifications
Power supply 120 volt
Heater element 1500 watt
Tank capacity (to fill level) 2 gallons (7.5 ltrs)
Main Features
The Earlex Steamers are professional,
fast-action steam wallpaper strippers.
They
have many added features;
l
Each tank is individually pressure tested.
l
Storage for the hose and the mains lead.
l
Neon mains On/Off switch.
l
Cooler running steam hose.
STEAMMASTER
l
MAX weight for standing on the unit is 300lbs and no more than one
person.
l
Do not permit oil, grease or slippery material to accumulate on the step.
l
Do not allow objects to accumulate on the step
l
Do not use a ladder or other device on the step to gain greater heights.
l
Do not apply impact loads to the step.
PRO-STEAM
l
NEVER stand on the unit or
use it as a platform.
ENGLISH
Please read these instructions carefully before use.
2
PS0176 0507 21/5/08 4:03 pm Page 2
3
PREPARATION
To achieve fastest paper removal always
gently score the areas to be stripped. With
heavily embossed, vinyl coated or painted
papers this is essential. Either use a
proprietary perforator tool or alternatively score
the paper with the edge of a wall scraper in a
criss-cross pattern with 150mm (6 inch)
spacing. As with all decorating work be sure to
protect carpets and furniture with covers.
IF THE
PLASTER ON
YOUR WALL IS
NOT SOUND IT
IS POSSIBLE
THAT THE
STEAM WILL
CAUSE THIS TO
BLOW AND
REQUIRE
REPLACING.
CHECK THAT THE PLASTER IS SOUND
BEFORE YOU PROCEED.
OPERATION
STEAM IS HOT! The unit is designed for safe,
fast removal of wallpaper but you must be aware
that steam is produced at 100oC so be careful,
wear protective clothing and protect your hands
with heat resistant gloves or mitts.
Place the unit on a flat surface near to the
area to be stripped. Remove the steam plate.
FULLY UNCOIL the hose and mains lead.
Connect the thread on the steam plate to the
end of the hose. This only needs to be hand
tight. DO NOT OVERTIGHTEN.
If the steam plate is fitted with a metal
swivel joint, tighten hose nut to thread using two
spanners. The plate can remain
permanently attached to the hose
thereafter.
To fill the unit, remove the filler cap and fill to the
maximum water level as shown on the glass
panel at the end of the tank. This must be clean
water, preferably hot. DO NOT USE ADDITIVES
- DO NOT
OVERFILL.
Connect the mains
lead from the unit to
the socket and
switch on. The mains
switch on the unit
has a neon light and
will light when the
unit is on. It will take between 25 and 35 minutes
for the unit to start producing steam depending
on the temperature of the water used. DO NOT
LEAVE UNATTENDED.
Once steam is being produced at the steam
plate you are ready
to commence
operation.
Prior to the steam
being produced a
small amount of
bubbling will occur
at the steam
plate. WARNING:
Beware of hot
water discharge
prior to steam emission. When the steam has
been produced, lift the steam plate above the
level of the tank outlet to allow
condensed steam to run back down the hose
and into the tank.
If you are right handed hold the steam plate in
your left hand and place flat against the wall
where you wish to commence removing.
Leave the plate against the wall for
approximately 10 seconds. If you are left
handed you may find it easier to operate with the
other hand.
Move the steam plate to the section
immediately next to where you have just been
working and use a wallpaper scraper to remove
the section that has just been steamed. By
working in this way you should be able to
remove paper continually. You may have to
leave the plate against the wall for longer
periods with some papers or re-steam if not
completely removed.
The water level is shown through the glass level
indicator and should not be allowed to fall below
minimum. Switch the
unit off when this level
has been reached.
If you require further
use of the steamer,
allow the unit to cool
for a minimum of 5
minutes. Remove the
filler cap carefully.
Beware of steam. Refill to the level indicator as
before and follow the above instructions.
YOU MUST NEVER
ALLOW THE UNIT T
O
BOIL DRY
PS0176 0507 21/5/08 4:03 pm Page 3
4
There is a safety thermal cut-out device
fitted to the unit. If the unit is allowed to boil dry
this will operate and prevent further use. Switch
the unit off and allow it to cool for at least 5
minutes, refill with water and then switch on
again - the thermal cut-out should automatically
re-set. If this has not re-set allow a further
cooling period.
When you have finished using the unit allow
any remaining water to cool and then empty
the unit. We recommend flushing the tank out
with clean water before storing. NEVER
LEAVE WATER IN THE UNIT WHILST
BEING STORED.
Radiator Cap
To fit - screw onto the filler neck hand tight. Do
not overtighten.
To remove - ensure unit is switched off and has
stopped boiling. Wait for 5 minutes. Slowly
unscrew the cap, any remaining trapped steam
will be released from beneath the cap.
Caution
- steam is very hot -wear a glove and keep
face clear.
Refill to the level indicator as before
and follow above instructions.
DANGER FROM STEAM.
Accessories
A range of accessories is available for use with
your Earlex Professional Steamer,
SSP SMALL STEAM PLATE
For stripping small awkward areas. Plate size 6”
x 3”.
PPF1 PERFORATING TOOL
Porcupine Perforator for even faster removal of
wallcoverings. Porcupine perforates the paper
and allows steam to penetrate faster. Ideal for
vinyls, painted coverings and textured coatings.
Other Uses
The steamers can also be used to:
l
Remove Artex®.
l
Lift stuck down vinyl tiles.
l
Sterilise soil.
l
Kill garden weeds.
TROUBLE SHOOTING
Unit Fails to Boil
l
The thermal cut-out has operated. Switch
off, allow to cool, refill with water then switch
on again.
l
If using an extension lead - check that the
thermal re-set button on the extension lead
has not tripped out. Check that the extension
lead is rated at a minimum of 15 amps.
If the unit still will not operate return the unit to
the dealer or authorised agent to check the
thermal fuse link and element. ONLY
QUALIFIED ELECTRICIANS SHOULD
UNDERTAKE THIS WORK.
Unit keeps cutting out
l
Check that water is above minimum level.
l
Check that the extension lead is rated at
15 amps minimum and fully unwound.
l
Check that no additives have been used.
Steam escaping from Pressure Cap
l
Check for blockages in hose or steam plate.
l
Clean seating around cap area.
Descaling
To maintain peak performance of the unit,
particularly in areas of hard water, it may be
necessary to descale the element in the unit.
Proprietary descaling products can be used,
always follow the manufacturers instructions.
ONE YEAR HOME USE WARRANTY
Earlex professional steamers are guaranteed for six (6) months for rental purposes and one year for
ordinary use from date of purchase against defects in workmanship and materials.
Removal of grounding pin voids warranty.
NOTE: The warranty shall NOT apply if the unit has been tampered with, when repairs or attempted
repairs have been made by unauthorized persons, or where an item has been subject to misuse,
abuse, accident or damage in transit. No charges will be accepted for unauthorized parts, repairs or
services.
IN NO EVENT SHALL THE COMPANY BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL
DAMAGE.
Some States do not allow limitations on how long an implied warranty lasts and some States do not
allow the exclusion or limitation of incidental or consequential damages, so part or all of the above
limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you
may also have other rights which vary from State to State.
PS0176 0507 21/5/08 4:03 pm Page 4
Loading...