Eagle MMC/SD Card Reader For USB Installation Instructions

Pub. 988-0147-482

Installation Instructions for

MMC/SD Card Reader

For USB

These instructions will help you install your LEI Card Reader on your
computer. The card reader (sometimes called a card reader/writer or
card programmer) is designed for use with a USB port.

This device acts like an additional removable disk drive under Microsoft
Windows operating systems. It can read MMC (MultiMediaCard) and
SD (Secure Digital or SDC) cards. These are solid-state flash memory
devices about the size of a postage stamp.

NOTE:

If your computer is running Windows ME/2000/XP, a software
driver for this plug-and-play MMC reader is already installed on
your computer. To install the reader, simply plug the reader's USB
connector into an available USB port. If you are running Windows
98, see the installation instructions below.



Minimum requirements are: a computer equipped with a USB port; Mi­crosoft

NOTE:



Windows operating system versions 98/ME/2000/XP.

If your computer does not have a USB port, call our customer serv­ice phone number on the back of this instruction sheet. We can ex­change your USB card reader for a parallel port MMC reader. The
parallel port version does not read SD cards.

INSTALLATION FOR WINDOWS 98

CAUTION:

Some older PCs running Windows 98 or Windows 98SE may
have hardware issues that cause conflicts with USB ports.

Some of the symptoms include Windows shut down problems or
the system locks-up while performing various functions.

If you experience these problems after installing your card
reader, uninstall the card reader and its driver software. Then
visit the web site www.usbman.com for possible solutions.

NOTE:

Install the driver first, before plugging in the device.

1

1. Turn off all other applications. (We recommend that you disable any
virus scanning software before beginning the installation. You can turn
the virus scanning program back on after driver installation is com­plete. To do this, refer to the virus scan software's instruction manual.)

2. Insert the CD-ROM containing the drivers into your CD drive. (If you
purchased the card reader along with MapCreate 6, insert the USA-
West, disc 1.)

3. Click

4. Type

S

TART|RUN

D:\USB-MMC Reader\Setup.exe

.

(where D: is the drive letter for

your CD-ROM).

5. Click

to begin installation.

OK

6. Follow the on-screen instructions.

7. When the installation program is finished, shut-down your computer.
Next, plug the reader into a USB port and turn your computer back on.

8. As Windows starts, you will see it find your new hardware and soft­ware. After the "new hardware" messages disappear, your reader is in­stalled. You can now transfer files to and from your MMC card or SD
card. You can also format your cards. Windows will display your MMC
reader as a removable disk drive.

MMC card reader appears as removable disk drive (H:) in this example.

9. Remember to restart any virus scan software you may have disabled.

2