DV Mark DV7 Booster Owner`s Manual

GETTING STARTED
BOOST - To set up the Level Boost, plug your instrument into the Input Jack (5), and connect the
Output Jack (6) to your amplier, after connecting a +9/+12VDC to the DC IN (7) or powering the pedal with a standard 9V battery. Turn the boost on using the right footswitch (3), making sure the LED on the Level Boost slider is ON (this indicates that the eect is active). Next, adjust the Level Boost slider while toggling the footswitch (3) on and o, comparing the volume of the direct signal with the boosted signal. Match the gain level as closely as you can to the direct signal, then adjust the Level Boost slider to the desired amount of added gain or cut. A suggested use of the boost is to leave it turned o until it’s time to solo, then switch it on (3) for a quick level boost when you begin your solo. You can easily apply this to ANY situation where you need two dierent, quickly accessible playing volumes. 7-BAND GRAPHIC EQ - To audition the EQ, rst step on the left footswitch (4), making sure the LEDs on the EQ sections are ON (this indicates that the eect is active) and with the EQ sliders (2) in at position (0 dB). Next, dial them in gradually one slider at a time to discover how they aect your sound EQ, and taylor your guitar tone.
TECHNICAL SPECS
INPUT IMPEDANCE: OUTPUT IMPEDANCE: BOOSTER: GRAPHIC EQ: Freq. (Hz): 50, 100, 250, 400, 800, 1600, 4000
Level (-16dB, +16dB)
POWER REQUIREMENTS- DC INPUT: +9/+12VDC DIMENSIONS: WEIGHT:
BLOCK DIAGRAM
In
Level
booster
1Mohm / 6 Vpp 470 ohm / 6 Vpp 0 to +20 dB
98.8 x 38.3 x 124.2 mm / 3.89” x 1.51” x 4.92” 420 g / 0.93 lbs
or standard 9-volt battery
100
400
1.6K
50
250
800
4K
equalizer
Out
OWNER’S MANUAL
+39 085 440 77 64 - www.dvmark.it - info@dvmark.it
LIMITED WARRANTY
DV Mark oers an international limited warranty on DV Mark products purchased from any
authorized DV Mark dealer, eective from the day of purchase. The terms of this warranty
vary from country to country; please contact the DV Mark distributor in your country for
details.
Please register this product online at www.dvmark.it to establish the date of purchase.
However, please note that you are required to retain a copy of your receipt as proof of
purchase in order to receive warranty service.
This warranty does not apply to any damage to the product caused by misuse, mishandling,
normal wear and tear (worn paint, scratches, etc.) are not covered by this warranty. DV Mark
reserves the right to be the sole arbiter regarding the misuse or abuse of this product.
DV Mark assumes no liability for any incidental or consequential damages, which may result
from the failure of this product. Any warranties implied in fact or by law are limited to the
duration of this express limited warranty. Your legal rights related to the warranty will vary
depending on the country of purchase.
WARRANTY CARD
This product is guaranteed by the warranty provided in the country of purchase, under the
following conditions:
A - The DV Mark warranty is only applicable if this document been properly completed (here
or online) and if the original invoice/bill of sale, mentioning model, serial number and
purchase date, is presented together with this document.
B - The obligations of DV Mark are limited to the repair of defects. Warranty repair eligibility
will be decided at the sole discretion of DV Mark or its representatives. Freight, freight
insurance costs, and any other costs related to the repair of this product are not covered by
this warranty.
C - All warranty repairs must be made by DV Mark or an authorized DV Mark (PARSEK) service
center.
D - This warranty does not apply in the following instances:
• if the damage was caused by accident, negligence or modications; use of non DV Mark
spare parts; or improper use, installation or packing;
• if the serial number on the equipment is illegible;
• if the damage was caused by lightning, water, re, incorrect main voltage, insufficient
ventilation or any other cause beyond the control of DV Mark.
E - DV Mark reserves the right to redesign or improve/modify its product at any time without
any obligation to modify previously manufactured products.
Parsek srl. - Italy - 66020 San Giovanni Teatino (Ch) - Via Po, 52/A Tel. +39 085 446 37 55 - Fax
1. IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions;
2) Keep these instructions;
3) Heed all warnings;
4) Follow all instructions;
5) Do not use this apparatus near water;
6) Clean only with dry cloth;
7) Install in accordance with the manufacturer’s instructions;
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatuses (including ampliers) that produce heat;
9) Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the apparatus;
10) Only use attachments/accessories specied by the manufacturer;
11) Unplug this apparatus during lightning storms or when unused for long periods of time;
12) Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged in any way, such as when the power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, or when the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped;
13) “Warning: to reduce the risk of re or electric shock, do not expose this apparatus to rain or moisture; and objects lled with liquids, such as vases, should not be placed on this apparatus”;
14) The socket outlet shall be installed near the equipment and shall be easily accessible;
15) The power cord must be unplugged prior to servicing.
1. PRÉCAUTIONS D’EMPLOI
1) Lire ces instructions;
2) Conserver ces instructions;
3) Suivre tous les conseils d’utilisations;
4) Suivre toutes les instructions;
5) Ne pas utiliser cet appareil au bord de l’eau;
6) Nettoyer uniquement avec un chion humide;
7) Ne pas bloquer le système de ventilation. Installer conformément aux instructions du fabricant;
8) Ne pas installer l’appareil près d’une source de chaleur tel qu’un radiateur, un fourneau, ou bien un autre appareil qui produit de la chaleur;
9) Protéger le cordon d’alimentation an qu’il ne soit pas piétiné ou écrasé tout particulièrement au niveau des ches, des prises de courant femelles, et des parties qui sortent de l’appareil;
10) Utiliser uniquement les accessoires recommendés par le fabricant;
11) Ne pas branché l’appareil en cas d’orage accompagné d’éclairs. Le débrancher en cas de non utilisation prolongée;
12) S’adresser à un service assistance agréé si l’appareil a subi des dommages, si le cordon d’alimentation ou la che a été endommagé, si un liquide a été renversé sur l’appareil ou bien si un object est tombé dans l’appareil, si ce dernier a été exposé à la pluie ou à l’humidité, s’il ne fonctionne pas correctement ou s’il est tombé;
13) “Avertissant: pour réduire le risque du feu ou de décharge électrique, n’exposez pas cet appareil à la pluie ou l’humidité et les objets remplis de liquides; tels que des vases, ne devraient pas être placés sur cet appareil”;
14) La prise de courant doit être installée près de l’appareil et doit être facilement accessible;
15) La che principale doit être débranchée avant toute opération d’entretien. MORE INFORMATION For warranty and service information, please contact your local DV Mark distributor (contact information available at www.dvmark.it). For more technical information, please visit us at www.dvmark.it and ll out the form on the Contact Us page. We hope you enjoy your eect pedal and use it to make great music!
“The Lightning Flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product
enclosure that may be of sufficient magnitude
to constitute a risk of shock to persons.”
“The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product.”
FUNCTIONS OVERVIEW
LEVEL BOOST (1) - This control increases your instrument’s volume without changing its
sound (from 0dB to 20dB). 7-BAND GRAPHIC EQ SECTION (2) – The 7 frequency bands were specically chosen because they are the most used for tailoring guitar tone:
- 50Hz for drop-D tuning
- 100Hz for heavy rhythm
- 250 Hz and 400 Hz shape the lower mids to give body and depth to the sound
- 800 Hz can be used for boosting for solos and/or power chord rhythms, or cutting for scooped tone and/or heavy rhythm
- 1.6 kHz can help you cut through the mix or cut for high-end scooped tone
- 4 kHz is for more presence and touch dynamics. Each band can be boosted or cut over a +/-16dB range. EQ can be very useful to eliminate feedback on your acoustic instruments.
BOOST SWITCH* (3) - The LED on the slider level indicates that the boost is engaged. EQ SWITCH* (4) - The LEDs on sliders indicates that the EQ is activated.
*TRUE BYPASS
TRUE BYPASS - When the pedal’s controls are ‘o’, your signal
goes directly from the input jack to the output jack without any degradation of audio quality.
CONNECTIONS
1/4” INPUT JACK - (connects to your instrument) (6) - Make sure that your amp is o and the
volume is turned down before making connections. Connect your instrument to the input of the DV7 Booster and the output of the DV7 Booster to your amplier.
1/4” OUTPUT JACK - (connects to your amplier) (7) DC IN (8) - External power supply connection: +9/+12VDC STANDARD 9V BATTERY COMPARTMENT (9) - Use a Phillips screwdriver to remove the two
screws to access the 9V battery compartment on the bottom side of the pedal.
DEALER INFORMATION
Dealer _________________________________ Dealer City ____________________________
Dealer Country__________________________
PERSONAL INFORMATION
Purchased by:
First Name _____________________________ Last Name ____________________________
Your Email Address ______________________ Address ______________________________
City ___________________________________ State/Prov ____________________________
Zip ___________________________________ Country______________________________
Do you want to join our mailing list? YES NO
MORE INFO (* not mandatory)
*Age __________________________________ *Sex_________________________________
*Occupation____________________________
WHERE DO YOU PLAY YOUR INSTRUMENT?
Stage / Performing Musician School / Student
Classroom / Educator Home Studio Recording
WHAT LEVEL OF PLAYER ARE YOU?
BeginnerAmateurSemi-Professional
Professional
PRODUCT PURCHASED VIA:
Internet Retail Store
WHAT MOST INFLUENCED YOUR BUYING DECISION?
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
You can ll out this form and send a copy to DV Mark (Parsek srl, Via Po 52, 66020 San Giovanni
Teatino, CHIETI ITALY) or, even better, you can now register your warranty online in a matter of
minutes, using our online registration form at www.dvmark.it. Simply point, click and type in
your information...and you’re done!
Registering your warranty identies you and your product, in case you are ever in need of
warranty service. Please note that in order to qualify for warranty service, you must retain a
copy of the sales receipt or bill of delivery as proof of purchase.
The information that you provide here will not be shared with any third parties and will be used
for DV Mark internal business purposes only.
PRODUCT INFORMATION
Model _________________________________ Serial Number _________________________
Date of Purchase_________________________(mm/dd/yyyy)
We’d like to thank you for choosing a DV Mark product.
If any problem occurs, please don’t hesitate to contact our support team at service@dvmark.it.
WARRANTY CARD
Loading...