Duracraft DW-CV610 Series, DW-CV610C Series Owner's Manual

TWIN WINDOW FAN

Model DW-CV610 Series
Model DW-CV610C Series

OWNER’S MANUAL

MIN MAX

READ AND SAVE THESE IMPORTANT
SAFETY INSTRUCTIONS BEFORE
USING THIS FAN.

WHEN USING ELECTRICAL APPLI­ANCES, BASIC SAFETY PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED
INCLUDING THE FOLLOWING:

1.

Use this fan only as described in
this manual. Other use not recom­mended may cause fire, electric shock
or injury.

2. This product is intended for house­hold use

ONLY and not for commer-

cial, industrial or outdoor use.

3. To protect against electrical shock,
do not, immerse unit, plug or cord in
water or spray with liquids.

4. This fan is equipped with a plug
having one blade wider than the
other. This plug will fit into the power
outlet only one way.

This is a safety

feature. NEVER

connect the fan to any
power source other than a 120 volt
outlet. If you are unable to insert the
plug fully into the outlet, try reversing
the plug. If the plug should still fail to
fit, contact an electrician to replace
the obsolete outlet.

Do not defeat the

safety purpose of this plug.

5.

Close supervision is necessary
when any appliance is used by or
near children.

6. Turn the fan to the OFF position
and unplug the fan from the outlet when
not in use, when moving fan from one
location to another and before cleaning.

7. Do not operate the fan in the presence
of explosive and/or flammable fumes.

8. Do not place the fan or any parts
near an open flame, cooking or other
heating appliance.

9. Do not operate the fan with a dam­aged cord, plug, after a malfunction
or if dropped or damaged in any
manner. (See warranty.)

10. Avoid contact with moving fan parts.

11. To disconnect, grip the plug and

pull it from the wall outlet. Never pull
by the cord.

12. The use of attachments not recom­mended by the manufacturer may be
hazardous.

13. Always use on a dry level surface.

14. Do not hang or mount fan on a

wall or ceiling.

15. Do not operate if the fan housing
is removed or damaged.

16. This fan is rated for use as a win­dow fan, however, we recommend
that during rain, the fan be removed
from the window.

WARNING: To reduce the risk of fire
or electrical shock, DO NOT USE THIS
FAN with any SOLID STATE Speed
Control Device.

INSTRUCTIONS FOR USE AND CARE

To attach the side
panels, line up the top
“notch” portion on the
side of the fan (A) with
the bottom of the
“groove” portion of the
side panel (B) (Fig.1).
Slide the panel down
until firmly in place. If
panel does not attach
easily, try placing it on

the other side of the fan.
Your window fan has
been designed to fit
double hung, casement

or sliding windows with
minimum openings of
21

7

/8" wide x 12" high.

INSTALLATION INSTRUCTIONS

MIN MAX

For Double Hung Windows:

• Open your window at least 11” high.

• For FRESH AIR operation, (draws
in fresh air from the outside), hold
the fan so the front side faces you.

• For EXHAUST operation, (pulls
indoor air out of the room), turn the
fan so the back side faces you.

• Position the bottom of the fan in the
windowsill, making sure the power
cord is hanging inside the room.

• Hold the fan in place and lower the
window to the top of the fan. Be sure
that contact is made with the window
guides on the top of the fan (Fig. 2).

• Push in or pull out the side panels
as needed to properly fit your window
width.

For Casement Windows:

• Open your window at least 11” wide.

• For FRESH AIR operation, (draws

in fresh air from outside), hold the fan
so the front side faces you.

• For EXHAUST operation, (pulls
indoor air out of the room), turn the
fan so the back side faces you.

• Position one of the attached side
panels attached to the fan on the
windowsill, making sure the power
cords hanging inside the room.

• Hold the fan in place and slide the
window shut to the top of the fan. Be
sure that contact is made with the
window guides on the top of the fan
(Fig. 2).

• Push in or pull out the opposite side
panels as needed to properly fit your
window width. The fan should be
secure even if the side panel is not
long enough to fill the entire window.

• Identify the front and back sides of the fan. The front side has the
Duracraft name and the thermostat control. The backside has a recessed
carrying handle at the top to allow for ease in transporting.

WINDOW

GUIDE

A.

B.

Fig. 2

Fig. 1

• Turn fan to the OFF
position and unplug the
fan before cleaning.

• This fan does not
disassemble.

• Use only a soft, damp
cloth to gently wipe the
surface of the fan clean.

• DO NOT immerse the
fan in water and never
allow water to enter the
motor housing.

• DO NOT use gasoline,
paint thinner or other
chemicals to clean the fan.

• For storage, clean the
fan as instructed and
store it in its original box
or cover with plastic to
protect it from dust. Store
your fan in a clean, dry
place.

• Plug the fan into a 120
Volt AC wall outlet.

• Set the Control Switch
to your desired fan
speed: HI or LOW.

• To reverse the air flow
direction, manually turn
the fan around in the
window.

WARNING: To prevent
personal injury and/or
damage to the fan,
never lean or push on

fan while it is seated in
the window or during
operation. Do not lift
window while the fan
is operating. Be sure
that the fan is fully
secured in the window
at all times.

OPERATION

CLEANING AND STORAGE

THERMOSTAT OPERATION

When a comfortable
room temperature has
been reached, slowly
turn the thermostat

counter-clockwise,
toward MIN, until the fan
stops. The thermostat will
now turn the fan on and

off automatically to
maintain this comfort
setting.

ELECTRICAL RATINGS

This product has been
rated 1.18 amps at
120V, 60 Hz.

NOTE: IF YOU EXPERI­ENCE A PROBLEM,
PLEASE RETURN THE FAN
TO THE PLACE OF THE
ORIGINAL PURCHASE OR
SEE YOUR WARRANTY.
DO NOT ATTEMPT TO
OPEN THE MOTOR
HOUSING YOURSELF.
DOING SO MAY VOID
YOUR WARRANTY AND

CAUSE DAMAGE TO THE
FAN OR PERSONAL
INJURY. IF YOU HAVE
ANY QUESTIONS
REGARDING THIS FAN,
PLEASE CALL OR WRITE:

HONEYWELL INC.
CONSUMER RELATIONS
DEPARTMENT

TOLL FREE:
1-800-554-4558

Mail questions or
comments to:

Honeywell Consumer
Products Business
Consumer Relations
Dept.
250 Turnpike Road
Southborough, MA
01772

Please be sure to specify
model number.

Thank you for purchasing a
Duracraft®brand fan manu­factured by Honeywell.
For more information, please
visit us at
www.honeywell.com

©1999 ALL RIGHTS RESERVED. F1025.99
P/N 035-00370-000 Rev. 1
artwork# 043-50097-000

3 YEAR LIMITED WARRANTY

Limited Warranty Terms
and Conditions

You should first read all instructions
before attempting to use this product.

The enclosed Customer
Response card should be filled
out and returned within 7 days
of purchase.

A.

This 3 year limited warranty
applies to repair or replacement of
product found to be defective in mate­rial or workmanship during the war­ranty period. This warranty does not
apply to damage resulting from com­mercial, abusive, unreasonable use or
supplemental damage. Defects that
are the result of normal wear and tear
will not be considered manufacturing
defects under this warranty. You
should first read the instruction manual
before attempting to use this product.

THE MANUFACTURER IS NOT
LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES OF
ANY NATURE. ANY IMPLIED
WARRANTY OF MERCHANTABIL­ITY OR FITNESS FOR A PARTICU­LAR PURPOSE ON THIS PROD­UCT IS LIMITED IN DURATION
TO THE DURATION OF THIS
WARRANTY.

Some jurisdictions do
not allow the exclusion or limitation of
incidental or consequential damages,
or limitations on how long an implied
warranty lasts, so the above limitations

or exclusions may not apply to you.
This warranty gives you specific legal
rights, and you also may have other
rights which vary from jurisdiction to
jurisdiction. This warranty applies only
to the original purchaser of this prod­uct from the original date of purchase.

B. At its option, the manufacturer will
repair or replace this product if it is
found to be defective in material or
workmanship within the warranty
period. Defective product should
be returned to the place of purchase
in accordance with store policy.
Thereafter, while within the warranty
period, any defective product should
be returned to the manufacturer.

C. This warranty does not cover
damage resulting from any unautho­rized attempts to repair or from any
use not in accordance with the
instruction manual.

D. Return defective product, freight
paid with proof of purchase and
$10 US/$14.70 CAN check or
money order for handling, return
packing and shipping charges, to
Honeywell:
Attn: Returns Department
4755 Southpoint Drive
Memphis TN 38118 USA