Duracraft Dh8005, Dh8002, Dh8004, Dh8000 Owner's Manual

NATURAL COOL MOISTURE
WHOLE HOUSE HUMIDIFIER with Humidistat
Model DH-8000, DH-8002, DH-8004 & DH-8005
OWNERS MANUAL
READ ALL INSTRUCTIONS BEFORE USING THIS HUMIDIFIER. SAVE THE INSTRUCTIONS FOR EASY REFERENCE.
WHEN USING ANY ELECTRICAL APPLI­ANCE, BASIC SAFETY PRECAUTIONS SHOULD BE FOLLOWED INCLUDING:
1.
This humidifier may not work properly on an uneven surface. Always place this humidifier on a firm, flat and level surface.
2. Place this humidifier in an area where it is not accessible to children.
3. Do not place the humidifier near any heat sources such as stoves, radiators and heaters.
4. Before using the humidifier, check the power cord for any signs of damage. If the cord is found to be damaged,
DO
NOT USE
and return the humidifier to Duracraft under the warranty agreement for repair.
5. This product is equipped with a polarized AC-line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way.
This is a safety feature. NEVER
connect the humidifier to any
power source other than a 120V AC polarized outlet. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact an electrician to replace the obsolete outlet.
DO NOT defeat the
safety purpose of the polarized plug.
6.
The humidifier should always be unplugged and emptied when not in operation or while being serviced or cleaned.
7. Never tilt or attempt to move the humidifier while it is operating or filled with water.
UNPLUG the humidifier
before moving.
8. This humidifier requires regular cleaning. Refer to the CLEANING instructions provided. Never clean the humidifier in any manner other than as instructed in this manual.
9. Turn the humidifier OFF if the relative humidity exceeds 60%, or if you notice moisture on the inside of your windows. For proper humidity readings use a hygrometer which is available in many hardware and department stores, or by ordering one from Duracraft (see Replacement Parts and Care Products).
IMPORTANT SAFETY INSTRUCTIONS
Thank you for purchasing a DURACRAFT
®
NATURAL COOL MOISTURE™ WHOLE HOUSE CONSOLE HUMIDIFIER with humidistat.
Before using your humidifier, we would like to explain the benefits of maintaining your home or office at the proper humidity level.
HEALTH
Your body needs moisture to stay healthy and comfortable. Dry air can be damag­ing and irritating. The Duracraft
®
Natural Cool Moisture Humidifier can help relieve:
Dry, itchy skin and chapped lips.
Cold symptoms and congestion.
Dry, scratchy throat and coughs.
For serious medical conditions, always consult your physician prior to use.
ENVIRONMENT
Maintaining the proper moisture level in your home or office with your Duracraft
®
Natural
Cool Moisture Humidifier will also:
Replace needed moisture in furniture.
Keep indoor plants moist and healthy.
Eliminate cracking and dryness in
wood furniture and fixtures.
Minimize static electricity.
HOW DOES IT WORK?
Dry air is pulled through the Natural Cool Moisture system and a quiet fan disperses invisible, moisture-balanced air. Unwanted minerals and bacteria from the water are trapped inside the Natural Cool Moisture filter. There is no "mist" or excessive condensation emitted.
The Duracraft
®
exclusive Automatic Moisture Balance System increases moisture output when the air is dry and lowers the moisture output when the humidity level is high. This automatically helps to adjust the output for maximum comfort and helps prevent condensation.
INTRODUCTION
Take the humidifier out of its carton. With the vented side away from you, remove the Top Grill and the water tank below it from the right side (Figure 1). Remove the power unit from the left side and lift out the Natural Cool Moisture filter assembly and filters. Then remove any addition­al packing material and the hardware packet con­taining the four swivel casters and screws.
To install the swivel casters, turn the base upside down and align the casters with the four mounting squares on the bottom of the base. Secure the four casters to the base using the holding screws provided (Figure 2).
Return the base to its original upright position.
Reposition the Natural Cool Moisture filter assembly with the arrows facing front. Insert the three Natural Cool Moisture filters into the assembly with the drainage on the bottom.
Select a firm, level, flat locationat least 6 inches (15 cm) from any wall for proper air flow and con­venient to an electrical outlet.
Place the humidifier on a water-resistant surface, as water can damage fur­niture and some flooring.
Duracraft will not accept responsibility for property damage caused by water spillage.
We recommend that the humidifier be disinfected prior to first use. Please see CLEANING instructions.
Remove the power unit
on the left side of the unit.
Remove the Top Grill
and the water tank below
it from the right side of the
unit (Figure 1).
To reduce residue
buildup, remove the
Natural Cool Moisture
filters before filling the hum-
idifier. Run them under cold
water. Turn the filters upside
down before repositioning
them in the reservoir base.
To help extend the life of
your filters, repeat this step
every time you fill your
humidifier.
Turn the water tank
upside down and remove
the fill cap by turning
counter-clockwise. If the
water tank will not fit
under a faucet for direct
filling, use the Fill Hose.
Fit the funnel end of the
hose over the faucet and
place the small end into
the water tank (Figure 3).
SET UP
FILLING
Fig. 1
Fig. 3
Fig. 2
Loading...
+ 8 hidden pages