Ducati Desmosedici 2008 Installation Instructions Manual

R

2008 Ducati Desmosedici Z-Fi Installation Instructions

P/N F143

WARNING!

USE ONLY IN RACE OR OTHER CLOSED COURSE APPLICATIONS AND NEVER ON PUBLIC ROADS

Z-Fi products do not meet California CARB highway requirements

Parts List:

Z-Fi Control Unit

Mounting Bracket

Fuel Harness

Download Z-Fi Mapper Software & Its Instructions from Website

USB Cable

O2 Eliminators (2)

Scotchlok (2)

Swingarm Stickers

Read through all instructions before beginning installation. This is not a replacement for the ECU.

This document is intended for use by qualied technicians. For more specic stock component identition

and location information refer to a factory service manual.

To create the ideal map(s) we recommend using the optimal Z-AFM self-tuning module

15330 Faireld Ranch Rd., Unit E, Chino Hills, CA 91709 Phone [phone] Fax [phone]

www.Bazzaz.net

BAZZAZ HARNESS CONNECTOR IDENTIFICATION

Ground

Speed

Crank

TPS

Map select

Z-AFM

Injectors

Neutral

Power

FUEL HARNESS

1. Remove the following components: Both right & left upper side fairings, fuel tank.

2. Install the supplied control unit mounting bracket to the right side engine cover securing it in place us­ing the two top cover bolts. Insert the Bazzaz control unit into the bracket. Connect the Bazzaz harness to
the control unit and route the remainder between the frame and front cylinder into the engine compart­ment (photos 1 & 2).

Photo 1

Photo 2

3. The factory harness crank position and speed sensor connectors can be found secured inside the frame

near the front cylinder head. Disconnect the factory harness connector from the sensor connector and

install the corresponding Bazzaz harness connectors inline (photos 3, 4 & 5).

Speed

Crank

Photo 3

Bazzaz

Factory

Bazzaz Speed Installed

Photo 4

Bazzaz

Factory

Bazzaz Crank Position
Installed

Photo 5