Dual XC4100 User Manual

INSTALLATION/OWNERS MANUAL
AM/FM/CASSETTE Receiver
XC4100
XC4100 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
• Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.
DIN mounting procedure: Install mounting sleeve into dash opening, bending tabs to secure.
2-Shaft mounting procedure: Remove knobs, faceplate and DIN mounting adapters from unit. Install unit into kit or dash opening from behind. Adjust rear shaft nuts to correct depth. Install faceplate and knobs.
Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
2
KEYS
XC4100 INSTALLATION
Installation
3
Typical 2-Shaft Mounting
Typical DIN Mounting
SHAFT NUTS
KNOBS
SHAFT NUTS
KNOBS
MOUNTING SLEEVE
DIN ADAPTERS
DASH OPENING
OR INSTALLATION KIT
XC4100 INSTALLATION
Wiring
Diagram
4
FUSES
When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage radio. The XC4100 uses one 3 amp AGC fuse (Ignition) and one .5 amp AGC fuse (Remote turn-on) located in-line.
Antenna Connector
Rear Preamp Output
GREY
Connect to amplifier RCA Input
.5 AMP AGC Fuse
Remote Turn-On
BLUE
Connect to amplifier or power antenna. Insulate wire if not used.
Ground
BLACK
Connect to vehicle chassis ground.
Accessory
RED
Right
Gray/Black (-) Gray (+)
Left
White/Black (-) White (+)
3 AMP AGC Fuse
Connect to existing ignition circuit or switched 12 volt source.
RCA Cable
(sold separately)
AMP
XC4100 OPERATION
Control Locations
5
Power/Volume Band Stereo Indicator FM Indicator Mono/Stereo
Tuning Balance Bass Boost Auxiliary Input Eject/Fast Forward
8910
1
1 2 3
8
4 5
6
9
10
7
2 5 6
3 4 7
General Operation
Turn POWER knob clockwise to turn the unit on. Turn POWER knob counter-clockwise until a click is heard to
turn the unit off. Insert a cassette to begin playback. Turn
POWER knob clockwise or eject cassette to begin
or resume tuner operation. Insert a standard 3.5 mm (line or headphone output) plug into
the auxilary input to listen to a portable CD or MP3 player.
Power On/Off
Cassette Mode
Tuner Mode
Auxilary Mode
XC4100 OPERATION
6
General Operation (continued)
Press BASS to activate and deactivate bass boost curve. Activating this feature will enhance the bass frequencies when listening to music at low volumes.
Adjust volume by turning
VOL knob clockwise or
counter-clockwise. Adjust balance by turning
BAL knob clockwise or
counter-clockwise.
Bass Boost
Volume
Balance
Cassette Player Operation
Insert a standard audio cassette into the cassette slot. The cassette will automatically begin playback.
Press the
EJECT button all the way in to stop and eject
the cassette. The unit will change to tuner mode. Press the
EJECT button half way in to fast forward.
Press
EJECT again to resume playback.
Insert Cassette
Eject
Fast Forward
Tuner Operation
Turn TUNE knob to select desired station. Press
MO/ST during FM tuner operation to select mono or stereo reception of the broadcast signal. The FM stereo LED indicator iluminates during FM stereo reception.
Press
BAND to select between FM and AM bands. The FM LED indicator illuminates when FM is selected.
Tuning
FM Mono/Stereo
Band
XC4100 WARRANTY
7
Limited One-Year Warranty
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
Namsung America Inc. warrants this product to the original purchaser to be free from defects in material and workmanship, under normal conditions, for a period of one year from the date of the original purchase.
Namsung America agrees, at our option, during the warranty period, to repair any defect in material or workmanship or to furnish an equal new or renewed product in exchange without charges, subject to verification of the defect or malfunction and proof of the date of purchase.
During the One-Year Warranty Period: For One Year from the date of purchase, your product will be replaced with a new, renewed or comparable product (whichever is deemed necessary) if it becomes defective or inoperative. This is done without charge to you. Replacement products are warranted for the balance of the original warranty period.
Who is covered? This warranty is extended to the original retail purchaser for products purchased and used in the U.S.A., in the 48 contiguous states ONLY.
What is covered? This warranty covers all defects in material and workmanship in this product. The following are not covered:
installation/removal costs, damage resulting from accident, misuse, abuse, neglect, product modification, improper installation, incorrect line voltage, unauthorized repair or failure to follow instructions supplied with the product, or damage occurring during return shipment of the product.
What to do? If the product requires warranty service, you must prepay the initial shipping charges. DUAL will pay the return shipping charges if the product is returned to an address within the USA.
Namsung America Inc. Attn: Returns Center 21318 64th Ave. South Kent, WA 98032 U.S.A. Toll Free: 1-866-626-7863
Exclusion of Certain Damages: This warranty is exclusive and in lieu of any and all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the companys negligence, actual or imputed. No person or representative is authorized to assume for the company any other liability in connection with the sale of this product. In no event shall the company be liable for indirect, incidental or consequential damages.
Namsung America Inc.
21318 64th Ave. South
Kent, WA 98032
Toll Free: 1-866-626-7863
©2003 Namsung America, Inc.
EVOK0403-V01
Specifications
Signal-to-noise: >40dB Frequency response: 60Hz-6.3kHz, ±3dB
Tuning range: 87.5MHz-107.9MHz Frequency response: 30Hz-13kHz, ±3dB
Tuning range: 530kHz-170kHz Frequency response: 80Hz-2kHz, ±3dB
Total system power: 30 Watts Peak Power output: 15Wx2 @ 14.4 VDC Power supply: 11-16 VDC, negative ground Speaker output impedance: 4 ohms Fuses: 3 amp fast blow AGC, .5 amp fast blow AGC Dimensions: 7.5" x 7" x 2.38" (191 x 178 x 60 mm)
Specifications subject to change without notice
Cassette Player
FM Tuner
AM Tuner
General
Loading...