DSC COMMUNIQUE Installation Instructions Manual
Intercom/Door Station
Installation Instructions
COMMUNIQUÉ
®
The Communiqué internal intercom station has a handsfree microphone and speaker
so that two-way communication can occur throughout the premises. The door station
can be mounted at any entrance point, acting as a doorbell which can also facilitate
two-way communication with anyone inside the premises. For more information
regarding the functions and operation of the intercom and door stations, please consult
the Communiqué Operation Manual.
Installation
1. Loosen the screw on the bottom of the unit and separate the backplate and
mounting plate from the main unit. See Figure 1.
2. Feed the station wires through the large square holes in the backplate and
mounting plate.
3. Fasten the backplate and the mounting plate to the wall with screws through the
large oval shaped holes in the plates.
4. Connect the wires as shown in Figure 2 or 3.
5. Fasten the front portion of the unit to the backplate and tighten the bottom screw
to secure it into place.
For programming instructions and Communiqué Wiring Diagram, please refer to the
Installation and Operation Manuals.
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by Digital Security Products Ltd. could void your authority to use this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Re-orient the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
The user may find the following booklet prepared by the FCC useful: “How to Identify and Resolve Radio/Television Interference
Problems”. This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402, Stock # 004-000-00345-4.
WARNING: Please refer to the System Installation Manual for
information on limitations regarding product use and function and
information on the limitations as to liability of the manufacturer.
Figure 1
Figure 2: Intercom Station Wiring
Figure 3: Door Station with Optional Connections to Existing Door Chimes
Intercom Station
To Communiqué
Control Unit
G
R
B
Y
G
R
B
Y
Door Station
To Communiqué
Control Unit
G
R
B
Y
G
R
B
Y
OR
BR
Existing Door Chime Button
{Parallel Connection}
To existing
door chimes
To chimes
transformer
(16-24
VAC)
LIMITED WARRANTY
Digital Security Controls Ltd. warrants the original purchaser that for a
period of twelve months from the date of purchase, the product shall be
free of defects in materials and workmanship under normal use. During
the warranty period, Digital Security Controls Ltd. shall, at its option,
repair or replace any defective product upon return of the product to its
factory, at no charge for labour and materials. Any replacement and/or
repaired parts are warranted for the remainder of the original warranty or
ninety (90) days, whichever is longer. The original owner must promptly
notify Digital Security Controls Ltd. in writing that there is defect in
material or workmanship, such written notice to be received in all events
prior to expiration of the warranty period.
International Warranty
The warranty for international customers is the same as for any customer
within Canada, the United States and Mexico, with the exception that
Digital Security Controls Ltd. shall not be responsible for any customs
fees, taxes, or VAT that may be due.
Warranty Procedure
To obtain service under this warranty, please return the item(s) in ques-
tion to the point of purchase. All authorized distributors and dealers
have a warranty program.
Conditions to Void Warranty
This warranty applies only to defects in parts and workmanship relating
to normal use. It does not cover:
• damage incurred in shipping or handling;
• damage caused by disaster such as fire, flood, wind, earthquake or
lightning;
• damage due to causes beyond the control of Digital Security Controls
Ltd. such as excessive voltage, mechanical shock or water damage;
• damage caused by unauthorized attachment, alterations, modifica-
tions or foreign objects;
• damage caused by peripherals (unless such peripherals were sup-
plied by Digital Security Controls Ltd.);
• defects caused by failure to provide a suitable installation environ-
ment for the products;
FCC COMPLIANCE STATEMENT
CAUTION: Changes or modifications not expressly approved by Digital Security Products Ltd. could void your authority to use this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Re-orient the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for help.
The user may find the following booklet prepared by the FCC useful: “How to Identify and Resolve Radio/Television Interference
Problems”. This booklet is available from the U.S. Government Printing Office, Washington D.C. 20402, Stock # 004-000-00345-4.
WARNING: Please refer to the System Installation Manual for
information on limitations regarding product use and function and
information on the limitations as to liability of the manufacturer.
LIMITED WARRANTY
Digital Security Controls Ltd. warrants the original purchaser that for a
period of twelve months from the date of purchase, the product shall be
free of defects in materials and workmanship under normal use. During
the warranty period, Digital Security Controls Ltd. shall, at its option,
repair or replace any defective product upon return of the product to its
factory, at no charge for labour and materials. Any replacement and/or
repaired parts are warranted for the remainder of the original warranty or
ninety (90) days, whichever is longer. The original owner must promptly
notify Digital Security Controls Ltd. in writing that there is defect in
material or workmanship, such written notice to be received in all events
prior to expiration of the warranty period.
International Warranty
The warranty for international customers is the same as for any customer
within Canada, the United States and Mexico, with the exception that
Digital Security Controls Ltd. shall not be responsible for any customs
fees, taxes, or VAT that may be due.
Warranty Procedure
To obtain service under this warranty, please return the item(s) in question to the point of purchase. All authorized distributors and dealers
have a warranty program.
Conditions to Void Warranty
This warranty applies only to defects in parts and workmanship relating
to normal use. It does not cover:
• damage incurred in shipping or handling;
• damage caused by disaster such as fire, flood, wind, earthquake or
lightning;
• damage due to causes beyond the control of Digital Security Controls
Ltd. such as excessive voltage, mechanical shock or water damage;
• damage caused by unauthorized attachment, alterations, modifications or foreign objects;
• damage caused by peripherals (unless such peripherals were supplied by Digital Security Controls Ltd.);
• defects caused by failure to provide a suitable installation environment for the products;
• damage caused by use of the products for purposes other than
those for which it was designed;
• damage from improper maintenance;
• damage arising out of any other abuse, mishandling or improper
application of the products.
Digital Security Controls Ltd.’s liability for failure to repair the
product under this warranty after a reasonable number of attempts
will be limited to a replacement of the product, as the exclusive
remedy for breach of warranty. Under no circumstances shall Digital Security Controls Ltd. be liable for any special, incidental, or
consequential damages based upon breach of warranty, breach of
contract, negligence, strict liability, or any other legal theory. Such
damages include, but are not limited to, loss of profits, loss of the
product or any associated equipment, cost of capital, cost of substitute or replacement equipment, facilities or services, down time,
purchaser’s time, the claims of third parties, including customers, and injury to property.
Disclaimer of Warranties
This warranty contains the entire warranty and shall be in
lieu of any and all other warranties, whether expressed or
implied (including all implied warranties of merchantability
or fitness for a particular purpose) And of all other obligations or liabilities on the part of Digital Security Controls Ltd.
Digital Security Controls Ltd. neither assumes responsibility
for, nor authorizes any other person purporting to act on its
behalf to modify or to change this warranty, nor to assume
for it any other warranty or liability concerning this product.
This disclaimer of warranties and limited warranty are
governed by the laws of the province of Ontario, Canada.
WARNING: Digital Security Controls Ltd. recommends that
the entire system be completely tested on a regular basis.
However, despite frequent testing, and due to, but not limited
to, criminal tampering or electrical disruption, it is possible
for this product to fail to perform as expected.
©2001 Digital Security Controls Ltd.
Toronto, Canada • www.dsc.com
ENGLISHENGLISH
ENGLISHENGLISH
ENGLISH: Tech Line: US & Canada:1-800-387-3630
FRENCHFRENCH
FRENCHFRENCH
FRENCH: Centre d’aide technique: US & Canada: 1-877-285-6655
SPANISHSPANISH
SPANISHSPANISH
SPANISH: Líneas Tech: US & Canada: 1-800-387-3630
Mexico: 1-800-514-1248 Puerto Rico: 1-877-651-1249
Printed in Canada 29002451 R002
Loading...