Drive R728RD User Manual

assembly instructions

Do not attempt to adjust or operate Rollator without

carefully reading all instructions in this manual.

1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.

2. Open frame and slide padded backrest into

frame brackets making sure snap bottoms
protrude through holes.

3. Unscrew tightening knob from handle and

insert handle tube into frame at desired
height lining up holes appropriately. Slide bolts
through holes from the inside and screw on
tightening knob until secure.

safety precautions

1. Please make sure the Rollator is fully opened,

seat is down and the folding bar under seat is locked
in the down position.

2. Be sure that both knobs are fully tightened and

are at equal heights. Test Rollator for stability before
applying full weight to hand grips.

3. Test the loop locks before operating the

Rollator. When wheels are locked (see
illustrations for locking and releasing locks below),
lock bar on rear wheels should prevent wheels from
turning. If the wheels turn while brakes are
locked, please take unit back to dealer for
adjustment. When locks are released,
the wheels should turn freely.

4. Always lock loop locks before sitting and do not

use seat when unit is on an incline or uneven
ground. 5. Replace tires when significantly worn or
damaged.

6. Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.

loop lock operation

Always engage and disengage wheel locks on both sides
simultaneously.

1. To Slow Down or Come to a Temporary Stop —

Pull up slowly on the loop locks with four fingers
until unit slows down or comes to a temporary
stop.

2. To Temporarily Lock Wheels in Position — Press

down on both loop locks with palms until you hear a
“click” that will tell you wheels are locked.

3. To Release Wheel Locks — Push up on both

loop locks with palms of hand to original
position.

instrucciones de armado

No intente ajustar u operar el andador rollator sin leer

cuidadosamente todas las instrucciones de este manual.

1. Primero quite todo el contenido de la caja:
respaldar, mango con tubo, marco del Andador
Rollator y Cesta.

2. Abra el marco y deslice el respaldo acolchado en
el marco de los frenos asegurándose que los
botones protruyan por los agujeros.

3. Desenrosque la perilla de ajustado del mango e
inserte el tubo del mango en el marco a la altura
deseada alineando los agujeros adecuadamente.
Deslice los tornillos a través de los agujeros desde
el interior y enrosque en la perilla de ajustado hasta
que estén firmes.

precauciones de seguridad

1. Por favor asegúrese que el andador Rollator esté
completamente abierto, que el asiento esté bajo y
que la barra plegable debajo del asiento esté
trabada en posición baja.

2. Asegúrese que ambas perillas esté
completamente ajustadas y estén a igual altura. Pruebe
la estabilidad del andador Rollator antes de apoyar
todo el peso en las empuñaduras.

ñ