Drive CE 1000 XL, PE 1000 XL User Manual

bariatric anterior
safety roller

with adjustable anterior safety roller

item#
CE 1000 XL - Bariatric Anterior Safety Roller
PE 1000 XL - Pediatric Anterior Safety Roller

Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.

This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.

In the event of a defect covered by this warranty, we
will, at our option, repair or replace the device.

This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components, such as rubber accessories, casters,
and grips, which are subject to normal wear and
need periodic replacement.

If you have a question about your Drive device
or this warranty, please contact an authorized
Drive dealer.

lifetime limited

warranty

© 2006 Medical Depot, Inc. All rights reserved.

Drive is a trademark of Medical Depot, Inc.

Port Washington N.Y. 11050 USA Made in China

EU Authorized Representative
Drive International, LLC
Globe Lane - Stockport
DUKINFIELD SK16 4RE, GB

assembly

1. Remove Safety Roller from carton.

2. Unfold Safety Roller by lifting ring (Fig 2) from left
upright and open frame.

3. Lift handlebar and position over left upright. Guide
handlebar into cradles (F).

4. Make sure spring button (A) snaps into hole on the
handlebar underside.

adjustments

Recommended handlebar height is at the wrist with arms fully
extended. With your hand placed on the handgrip, your elbow
should be flexed 20° - 30°.

HEIGHT

1. Open both height adjustment knobs (B).

2. Push in spring button (C), one side at a time and
raise or lower uprights to desired height.

3. Tighten knobs.

WIDTH

1. Open knob on handlebar (D) and on crossbar (E).

2. Extend telescoping tubing on handlebar and crossbar to
desired width.

3. Tighten knobs (D & E).

NOTE: When Safety Roller is fully extended, spring buttons on
the underside of handlebar and crossbar will snap into position.
Press in both spring buttons if narrower width is desired.

folding instructions

1. Press spring button (A) on left side of handlebar and lift
handlebar.

2. Hold handlebar in right hand and with left hand, swing
left upright outward and squeeze into Z position until
fully folded.

3. Drop handlebar over folded Safety Roller.

4. Secure the uprights by putting the ring over the left
upright and under the spring button.

accessories

Adjustable forearm platforms, seat, variable resistance tabs
on rear wheels, swivel wheel locking brackets, ankle prompts,
trunk support, extended uprights for additional height, IV pole
and oxygen tank holder.
Call an authorized Drive dealer for detailed information about
our accessories.