Drive KA2200-2GCR, KA1200-2GCR, KA1200-2GWP, KA1200-2GKB, KA2200-2GKB User Manual

EU Authorized Representative
Drive Medical LTD
Ainley’s Industrial Estate
Elland, West Yorkshire,
United Kingdom HX5 9JP

Your Inspired by Drive branded product is warrantied
to be free of defects in materials and workmanship for
the lifetime of the product for the original consumer
purchaser.

This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confidence
in the materials and workmanship of our products
and our assurance to the consumer of years of
dependable service.

This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non- durable
components, such as rubber accessories, casters,
and grips, which are subject to normal wear and need
periodic replacement.

If you have a question about your Inspired by Drive
device or this warranty, please contact an authorized
Inspired by Drive dealer.

Rev.2.1.10.17

Limited Lifetime Warranty

by

NIMBO POSTERIOR WALKER

Item #

KA1200-2GCR, KA1200-2GKB, KA1200-2GWP,
KA2200-2GCR, KA2200-2GKB, KA2200-2GWP,
KA3200-2GCR, KA3200-2GKB, KA3200-2GWP,
KA4200-2GCR, KA4200-2GKB, KA4200-2GWP,
KA5200-2GEB

2017 Medical Depot, Inc. All rights reserved.

Drive DeVilbiss Healthcare

user instructions

1. Remove Nimbo from carton.

2. To unfold the Nimbo, pull handgrips and cross
brace in opposite directions. Continue to unfold
until the push pins “click” into place.

3. To install the legs, match the leg numbers with the
corresponding frame numbers. Depress the push
pins on the legs and slide into the frame. When
locked into position, the push pins will “CLICK”
through the frame.

4. Adjust height of walker by pressing push pins on
each leg and slide leg to desired position.

FIGUREA

INCORRECTPUSHPINSCORRECTPUSHPINS

FRONT

OF

WALKER

1. Lift and position knob (A) to set front wheels in
either the swivel or locked position.

maintenance and care

1. Inspect the Roller regularly. Tighten the nuts
and bolts as necessary. If a product needs service
or replacement parts, contact an authorized Drive
dealer.

2. To clean the Roller, use warm water with a mild
detergent. Wipe clean with a soft, dry cloth.

FIGUREC

PICTUREINDICATES

UNLOCKEDPOSITION

OVERRIDE

BRACKET

user information

2. To fold the Nimbo, face it from the open end,
depress the push pins, tilt walker so that it rests
on its rear legs only and push the front legs toward
the rear legs.

3. To override the one-directional feature of the rear
wheels, lift up aluminum pin and insert into
override bracket

A

FIGUREB