Dometic RPD190, RPD 218 Installation And Operating Manual
M
O
D
E
M
O
D
E
EN
REFRIGERATION
REFRIGERATORS
Compressor refrigerator
Installation and Operating Manual
RPD190, RPD 218
EN
RPD190, RPD218
Please read this instruction manual carefully before installation and first
use, and store it in a safe place. If you pass on the product to another
person, hand over this instruction manual along with it.
Table of contents
1 Explanation of symbols. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
2 Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
3 Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
4 Intended use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
5 Technical description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
6 Installing and connecting the refrigerator . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
7 Using the refrigerator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
8 Cleaning and maintenance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
9 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29
10 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30
11 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
12 Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 34
3
EN
Explanation of symbols RPD190, RPD218
1 Explanation of symbols
DANGER!
D
!
Safety instruction: Failure to observe this instruction will cause fatal or
serious injury.
WARNING!
Safety instruction: Failure to observe this instruction can cause fatal or
serious injury.
CAUTION!
Safety instruction: Failure to observe this instruction can lead to injury.
!
NOTICE!
A
Failure to observe this instruction can cause material damage and impair
the function of the product.
I
NOTE
Supplementary information for operating the product.
4
EN
RPD190, RPD218 Safety instructions
2 Safety instructions
The manufacturer accepts no liability for damage in the following cases:
• Faulty assembly or connection
• Damage to the product resulting from mechanical influences and excess voltage
• Alterations to the product without express permission from the manufacturer
• Use for purposes other than those described in the operating manual
2.1 General safety
DANGER!
D
!
• On boats: If the device is powered by the mains, ensure that the
power supply has a residual current circuit breaker. The break distance
must not be less than 3 mm.
WARNING!
• Have a qualified technician perform the installation in wet rooms.
• Do not operate the device if it is visibly damaged.
• If this device's power cable is damaged, it must be replaced by the
manufacturer, customer service or a similarly qualified person in order
to prevent safety hazards.
• This device may only be repaired by qualified personnel. Inadequate
repairs may cause serious hazards.
• This device can be used by children aged 8 years or over, as well as by
persons with diminished physical, sensory or mental capacities or a
lack of experience and knowledge, providing they are supervised, or
have been taught how to use the device safely and are aware of the
resulting risks.
• Cleaning and user maintenance must not be carried out by children
without supervision.
• Children must be supervised to ensure that they do not play with the
device.
• Always keep and use the device out of the reach of children under 8
years of age.
• Do not store any explosive substances, such as spray cans with
propellants, in the device.
5
EN
Safety instructions RPD190, RPD218
CAUTION!
!
A
• Danger of crushing! Do not put your fingers into the hinge.
• Foodstuff may only be stored in its original packaging or in suitable
containers.
NOTICE!
• Check that the voltage specification on the type plate is the same as
that of the power supply.
• Never pull the plug out of the socket by the connection cable.
• If the refrigerator is connected to the DC socket: disconnect the
refrigerator and other electric consumers from the battery before
connecting the quick charging device.
• If the refrigerator is connected to the DC socket: disconnect the
refrigerator or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
• The refrigerator is not suitable for transporting substances which are
caustic or contain solvents.
• Keep the drainage outlet clean at all times.
• Do not open the refrigerant circuit under any circumstances.
• Never transport the device in a horizontal position, so that no oil can
leak out of the compressor.
• Make sure that the refrigerator circuit is not damaged during
transportation. The refrigerant in the refrigerator circuit is highly
flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.
• Set up the device in a dry location where it is protected against
splashing water.
2.2 Operating the device safely
DANGER!
D
• Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
CAUTION!
!
6
• Before starting the device, ensure that the power supply line and the
plug are dry.
EN
RPD190, RPD218 Scope of delivery
• If you connect the device to a battery, make sure that no food comes
into contact with the battery acid.
NOTICE!
A
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for that purpose.
• Do not place it near naked flames or other heat sources (heaters, direct
sunlight, gas ovens etc.)
• Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
• Ensure that the ventilation vents are not covered.
• Do not fill the inner container with ice or fluid.
• Never immerse the appliance in water.
• Protect the appliance and the cable against heat and moisture.
• Make sure that foodstuffs do not touch the walls of the cooling area.
3Scope of delivery
Quantity Description
1 Refrigerator
1 Lower ventilation grille
1Drain hose
2 Icecube tray
1 LH hinge conversion kit (with instruction)
2 Airing position card
1 Operating manual
7
EN
Intended use RPD190, RPD218
4 Intended use
The RPD series refrigerators are suitable for refrigerating foodstuffs and storing
frozen foodstuffs.
The device is also suitable for use on boats.
The device is designed to be operated from a 12 V or 24 V on-board supply socket
of a vehicle, boat or caravan as well as from a 100 – 240 V mains.
CAUTION! Health hazard!
!
The refrigerator is only suitable for installation in a fitted cavity. Once it is installed,
only the front of the appliance may be accessible.
Please check if the cooling capacity of the device is suitable for storing
the food or medicine you wish to cool.
5 Technical description
5.1 Function description
The device can refrigerate goods to +7 °C to +2 °C and keep them cool. Products
can be frozen to –10 °C to –18 °C in the freezer compartment. You can use the
variable thermostat to set the desired temperature.
The refrigerator is suitable for use with 12 V or 24 V DC voltage and can therefore also
be used e.g. for mobile homes, caravans or on boats. It can also be connected to a
100 – 240 V mains supply.
When used on boats the refrigerator can be subjected to a constant inclination of
30°.
All materials used in the refrigerator are compatible for use with foodstuffs. The
refrigerant circuit is hermetically sealed and CFC-free.
8
EN
RPD190, RPD218 Technical description
1
M
O
D
E
M
ODE
RPD190
3
1
4
6
5
22
3
1
4
6
5
RPD218
1
5.2 Control elements inside the refrigerator
The various types of refrigerators are shown in the following illustrations:
No. Description
1 Freezer compartment
2 Control panel
3 Wire shelf (folding, so that bottles can be put in the refrigerator)
4Shelf
5 Crisper bin
6 Door shelf
9
EN
Technical description RPD190, RPD218
MODE
1 2 3 4
5
6
2
5.3 Control elements
No. Description
1 P button (ON/OFF button)
2 Power LED
3 Status LED
4 MODE button
5 Temperature level LEDs
6
button (Temperature setting button)
10
EN
RPD190, RPD218 Installing and connecting the refrigerator
6 Installing and connecting the
refrigerator
Please note the following instructions for installation on boats:
DANGER!
D
A
If the device is powered by the mains, ensure that the power supply has
a residual current circuit breaker.
NOTICE!
• The device can be tilted sideways up to 30°. When setting up the
refrigerator, note that it must be fastened to take account of this. If
you have any questions regarding installation, consult your specialist
dealer.
• Install the refrigerator so that the warm air generated can easily flow
away (fig. 3, page 12)
• The appliance is designed for ambient temperatures between
+16 °C and +43 °C.
6.1 Reversing the doors
With the LH hinge conversion kit you can change the hinge of the door, so that it
opens to the left instead to the right. A separate instruction sheet is included with this
kit.
11
Loading...