Please read this manual carefully before installing and starting up, and
store it in a safe place. If you pass on the product to another person,
include this instruction manual with it.
Explosion hazard in explosive atmosphere
This component does not meet federal requirements for ignition protection.
Do not install in spaces containing gasoline engines, tanks,
LPG/CPG cylinders, regulators, valves or fuel line fittings.
Failure to comply can result in injury or death.
Electrical shock hazard
Disconnect the power cord before servicing or opening device.
Ultraviolet light is harmful
Eye damage may result from directly viewing the light produced by these
lamps. To reduce the risk of exposure to UV radiation, take UV radiation
protective measures for personnel during servicing.
Ultraviolet lamp may cause injury
Ultraviolet lamps are made of glass and are fragile. Safety eyewear and
puncture resistant gloves must be worn when handling an ultraviolet lamp.
Risk of exposure to excessive ultraviolet (UV) radiation. Do not operate
without complete lamp enclosure in place.
The health aspects associated with the use of this product and its ability to
aid in disinfection of environmental air have not been investigated by UL.
The effectiveness of this product has been tested and proven by
Environmental Diagnostics Laboratory, an AIHA accredited and SBA
certified laboratory.
18
Page 3
EN
_BreatheEasy_A5.book Seite 19 Dienstag, 24. Januar 2012 3:31 15
The manufacturer will not be held liable for claims for damage resulting from
the following:
Faulty assembly or connection
Damage to the product resulting from mechanical influences and excess
voltage
Alterations to the product without express permission from the manu-
facturer
Use for purposes other than those described in the operating manual
2.1General safety
DANGER!
D
Explosion hazard in explosive atmosphere
This component does not meet federal requirements for ignition
protection. Do not install in spaces containing gasoline engines,
tanks, LPG/CPG cylinders, regulators, valves or fuel line fittings.
!
WARNING!
Do not operate the device if it is visibly damaged.
This device may only be repaired by qualified personnel.
Inadequate repairs can lead to serious hazards.
Should your device need to be repaired, please contact
customer services.
Persons whose physical, sensory or mental capabilities or
whose lack of experience and knowledge prevent them from
using the device safely should not use it without supervision or
instruction by a responsible person.
Electrical devices are not toys.
Always keep the device out of the reach of children.
Children must be supervised to ensure that they do not play with
the device.
If this device’s power cable is damaged, it must be replaced by
the manufacturer, customer service or a similarly qualified
person in order to prevent safety hazards.
21
Page 6
EN
_BreatheEasy_A5.book Seite 22 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
Please contact your local service partner if you have questions regarding
spare parts.
5Intended use
The Dometic Breathe Easy™ (SKU 9108680632) is an air purifier that uses
photocatalytic nano-mesh technology and ultraviolet light to improve the air
quality by constantly circulating the air through the device.
NOTE
Note that the device does not fix the the source of ongoing odor
I
problems. For example, a leak that caused mold must be repaired
and the mold must be removed.
23
Page 8
EN
_BreatheEasy_A5.book Seite 24 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
The device is operated with 12 Vg. Connect it to a 100 – 240 V power supply
using only the power adapter (SKU 9108694411) provided.
6Technical description
No. in
fig. 1, page 3
1Fan
2Removable nano-mesh divider
3Ultraviolet lamp
4Non-removable nano-mesh strips
5Lamp socket
6Safety switch
No. in
fig. 2, page 3
1Power/Fan-speed switch
2Connection socket
3Maintenance sticker
Designation
Designation
7Installing the Breathe Easy™
When selecting the installation location, observe the following instructions:
The device is designed for rooms with an area of up to 500 sq. ft. (46 m²).
Select a location where the air flow is not impaired.
Do not install the device in rooms where flammable materials are stored
or flammable gases may accumulate.
Do not install the device near the inlet or outlet of an air conditioning
system.
Keep the power cable away from hot surfaces.
Install the device on a flat, smooth surface.
24
Page 9
EN
_BreatheEasy_A5.book Seite 25 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
➤ Fasten the device to a flat, smooth surface using the suction pads.
➤ Fill in the current date on the maintenance sticker (fig. 2 3, page 3). This
tells you when the ultraviolet lamp must be replaced in the following year.
8Using the Breathe Easy™
WARNING!
Eye damage may result from directly viewing the light produced by
!
➤ Connect one end of the 12 V power cable to the socket (fig. 2 2, page 3).
➤ Plug the other end of the cable into the 12 V source.
➤ Move the switch (fig. 2 1, page 3) to the required position:
these lamps. To reduce the risk of exposure to UV radiation, take
UV-radiation protective measures for personnel during servicing.
– II (maximum purification, recommended): The fan operates at maxi-
mum speed. The ultraviolet lamp is on (you can see a blue glow
through the vents).
– I: The fan operates at lower speed. The ultraviolet lamp is on (you can
see a blue glow through the vents).
– 0: The fan and the ultraviolet lamp are switched off.
9Replacing the ultraviolet lamp and the
nano-mesh divider
CAUTION! Ultraviolet lamp may cause injury
Ultraviolet lamps are made of glass and are fragile. Safety eyewear
!
Ultraviolet lamps have a limited service life. After around 9000 service hours
(about a year of continuous use) they lose their germicidal effectiveness. You
must therefore replace the lamp after this period, even if it still lights up.
I
and puncture resistant gloves must be worn when handling an ultraviolet lamp
NOTE
Each time you switch the ultraviolet lamp on and off, you reduce its
service life by about an hour.
25
Page 10
EN
_BreatheEasy_A5.book Seite 26 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)
No power (the device does not switch on, the fan cannot be heard)
➤ Check that the power cable is connected to the device and the power
source.
➤ Check that the switch (fig. 2 1, page 3) is in the I or II position.
➤ Verify that the power source is working.
Fan runs but no blue light can be seen
➤ Check that the ultraviolet lamp (fig. 1 3, page 3) is correctly inserted in
the socket (fig. 1 5, page 3) (see chapter “Replacing the ultraviolet lamp
and the nano-mesh divider” on page 25).
➤ Replace the ultraviolet lamp (fig. 1 3, page 3) if necessary (see chapter
“Replacing the ultraviolet lamp and the nano-mesh divider” on page 25).
➤ Check whether the lamp socket (fig. 1 5, page 3) is defective.
Output seems ineffective
➤ Make sure the device is correctly installed:
– In an enclosed room
– Not near the inlet or outlet of an air conditioning system
– The area of the room may not exceed 500 sq. ft. (46 m²)
Output seems low
➤ Clean the vents.
➤ Clean the removable nano-mesh divider (see chapter “Cleaning and car-
ing for Breathe Easy™” on page 27).
➤ Clean the ultraviolet lamp (see chapter “Cleaning and caring for
Breathe Easy™” on page 27).
➤ Check whether ultraviolet lamp needs to be replaced (look at the sticker
to see how long it has been in use).
28
Page 13
EN
_BreatheEasy_A5.book Seite 29 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact
RoadTrucker Inc
(www.RoadTrucker.com)
8312 Sidbury Rd.
Wilmington, NC 28411
(800) 507-0482 / (910) 686-4281
Breathe Easy™Guarantee
12Guarantee
The statutory warranty period applies. If the product is defective, please
contact your retailer or the manufacturer's branch in your country (see the
back of the instruction manual for the addresses).
For repair and guarantee processing, please include the following documents when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
Guarantee does not cover the ultraviolet lamp.
13Disposal
➤ Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the product, ask your local recycling
centre or specialist dealer for details about how to do this in
M
accordance with the applicable disposal regulations.
29
Page 14
EN
_BreatheEasy_A5.book Seite 30 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact
RoadTrucker Inc
(www.RoadTrucker.com)
8312 Sidbury Rd.
Wilmington, NC 28411
(800) 507-0482 / (910) 686-4281
Technical dataBreathe Easy™
14Technical data
Breathe Easy™
SKU:9108680632
Voltage:12 Vg
Current:666 mA
Consumption:8 W
Maximum room size:46 m² (500 sq. ft.)
Dimensions W x D x H158 x 114 x 48 mm (6.2" x 4.5" x 1.9")
Weight:Approx. 340 g (12 oz.)
Testing/certification:
89XK
E
Approved to standard 2009/19/EC (2004/104/EC), Automotive EMC
Directive
Different versions, technical modifications and delivery options reserved.
30
Page 15
_BreatheEasy_A5.book Seite 136 Dienstag, 24. Januar 2012 3:31 15
For Sales Information Please Contact RoadTrucker Inc (www.RoadTrucker.com)