Dometic BR36H70CR, BR36C71CR User Manual

C
F

°

°

MODE

FAN

Wall Mounted Control

User‘s Guide

Cold mode

Auto mode

Dehumidification
mode

Heat pump
mode

Ventilation mode

Timer

Fan speed

Select mode

Select fan speed

Power ON/OFF

Increase/decrease
temperature set-point

ON/OFF

Infrared receiving

window

Dometic Australia Pty Ltd

ABN 620 086 366 305

Tel: [phone]
Fax: [phone]

Contact Details:

1 John Duncan Court
Varsity Lakes, QLD 4227

Email: [e-mail]

P/N. 54-AA-MA38702

MOBICOOL Electronic(Zhuhai)Co.,Ltd

18,Jinhu Lu,Sanzao,Jinwan Zhuhai,China

Notice: The function of timer must use remote controller.

The remote controller is optional fitment.

M COMP

θ θ

POWER

POWER

L
N

Wiring Diagrams

Heat pump

BR36H70CR

Air conditioner

BR36C71CR

Wire connection

C
F

°

°

MODE

FAN

The basic steps for operating your Air Conditioner or Heat Pump are described in

this User‘s Guide. For more detailed information on modes of operation and special

features refer to the Operating Instructions Manual.

Quick reference to control buttons

4445101808 08/2016

C
F

°
°

MODE

FAN

Fault condition

Room temperature sensor fault

Communication fault

Defrosting instructions

Digital display code

E1
E2
E3
E4
H1

Evaporator sensor fault

Condenser sensor fault

Note

Call for service

Call for service
Call for service
Call for service

Indicates defrosting in progress

Note

OPT:condenser sensor temperature.

IPT:evaparator sensor temperature.

48°C

compressor will be contiunted

60°C, compressor is not working.

A. Preventing cold air function:

When heat mode is selected, the internal fan will
not start until the air within the air conditioner is

B. Blowing surplus heat function:

In heating mode, the fan will continue to run for appro­ximately 60 seconds aer the OFF button is pressed.

C. Defrosting function:

At low ambient temperatures approximately –5°C

the heating mode will periodically enter a defrosting

D. Overheat protection

≥

48°C,

•

•

•

heated. This is to prevent cold air blowing into the

In heating mode, detection of the evaparator
temperature IPT,

•

The compressor will keep

the original state.

≥

when IPT

<

IPT

≥

55°C.

when IPT

when

•

•

living space during start up.

mode.

Press “MODE” button select auto, cold,

d.

Press “ON/OFF” button switch on

Operation

a.

Press “+” button increase set

b.

temperature point.

c.c.

or switch off the machine.

dehumidification, heat, and fan mode.

Press “FAN” button adjust the high

Press “–” button decrease set
temperature point.

or middle and low speed of the motor.

working.

FAULT CODE & FUNCTION DESCRIPTIONS

Installation Instructions

Step One :

Remove the cover of wall mounted control box.

Step Two :

Remove the button from wall mounted control box.

Step Three :

According to the drawing install three screws one by one.

Step One

Step Two

Step Three

Step Four

Step Four :

Finally install the button and cover again.

C
F

°

°

MODE

FAN

C
F

°

°

MODE

FAN

C
F

°

°

MODE

FAN