INSTALLATION & OPERATING
INSTRUCTIONS
A-Frame Awning & Screen Room
Model 747AFRM17.XXX
INTRODUCTION ............................................................................. 2
IMPORTANT SAFETY INSTRUCTIONS AND DOCUMENT SYMBOLS .................................... 2
A. Recognize Safety Information ............................................................. 2
B. Understand Signal Words ................................................................ 2
C. Supplemental Directives ................................................................. 2
D. General Safety Messages ................................................................ 2
GENERAL INFORMATION ...................................................................... 3
INITIAL ASSEMBLY ............................................................................ 3
A. Assembling For The First Time ............................................................ 3
ASSEMBLY .................................................................................. 4
A. Erecting The Room. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
ROOM SETUP VARIATIONS ..................................................................... 6
TAKE DOWN ................................................................................. 6
A. Taking Down And Storing The Room ....................................................... 6
WARRANTY ................................................................................. 7
Read these instructions carefully. These instructions MUST stay with this product.
Dometic Corporation reserves the right to modify product appearances and specifications without notice.
REVISION B
Form No. 3314184.000 02/17
©2017 Dometic Corporation
LaGrange, IN 46761
USA
SERVICE OFFICE
Dometic Corporation
1120 North Main Street
Elkhart, IN 46514
CANADA
Dometic Corporation
46 Zatonski, Unit 3
Brantford, ON N3T 5L8
CANADA
SERVICE CENTER &
DEALER LOCATIONS
Visit:
www.eDometic.com
INTRODUCTION
This A-Frame Awning and Screen Room (hereinaer referred to as ”Screen Room”) is designed and intended to fit on most A-Frame
style pop-up campers (hereinaer referred to as “camper”). Use these instructions to ensure correct installation, function, and operation of the product.
Dometic Corporation reserves the right to modify appearances and specifications without notice.
IMPORTANT SAFETY INSTRUCTIONS AND DOCUMENT SYMBOLS
This manual has safety information and instructions to help you eliminate or reduce the risk of accidents and injuries.
A. Recognize Safety Information
This is the safety alert symbol. It is used to alert you to potential physical injury hazards. Obey all safety messages that follow
this symbol to avoid possible injury or death.
B. Understand Signal Words
A signal word will identify safety messages and property damage messages, and will indicate the degree or level of hazard
seriousness.
indicates a hazardous situation that, if NOT avoided, could result in death or serious injury.
indicates a hazardous situation that, if NOT avoided, could result in minor or moderate injury.
is used to address practices NOT related to physical injury.
Indicates additional information that is not related to physical injury.
C. Supplemental Directives
Read and follow all safety information and instructions to avoid possible injury or death.
Read and understand these instructions before installation of this product.
Incorrect installation of this product can lead to serious injury.
The installation MUST comply with all applicable local or national codes, including the latest edition of the following
standards:
U.S.A.
• ANSI/NFPA70, National Electrical Code (NEC)
• ANSI/NFPA 1192, Recreational Vehicles Code
CANADA
• CSA C22.1, Parts l & ll, Canadian Electrical Code
• CSA Z240 RV Series, Recreational Vehicles
D. General Safety Messages
Failure to obey the following warnings could result in death or serious injury:
• This product MUST be serviced by a qualified service technician.
• Do not use heaters, cooking grills, camp fires, camp stoves, or gas burning lamps inside the Screen Room.
• Never operate generators, motorcycles, or any internal combustion engines inside the Screen Room.
• Close attention is necessary when used by or near children. Do not allow children or adults to lean against the sides or front
of the Screen Room.
• Do not suspend electrical lights from the room’s poles or allow electrical lights to come in contact with the fabric of the
Screen Room.
• Do not modify or change the installation of this Screen Room.
• Use the Screen Room only as described in this manual.
2
GENERAL INFORMATION
REQUIRED TOOLS
Scissors
BASIC COMPONENTS
(1) Stowage Bag (1) Screen Room Fabric Assembly
(1) Sectioned Central Roof Pole (2) Extendable Side Roof Poles
(1) Sectioned Arch Pole (2) Sectioned Vertical Corner Poles
(25) Tent Stakes (2) Hold Down Straps
(1) Mesh Camper Skirt (1) 25-Foot Roll of Velcro (“hook” side only)
(12) 3-Inch Pieces of Velcro (“hook” side only) (6) Turnbuckles
OPTIONAL COMPONENTS AND KITS
Velcro Kit
Mallet
INITIAL ASSEMBLY
A. Assembling For The First Time
The following steps need to be completed only when installing the Screen Room for the first time.
STEP1
Turnbuckle
(Optional)
Velcro
Locations
• Lower the camper wall enough to reach its top edge.
• Secure Velcro to the top of the camper wall.
• Secure the 3-inch Velcro strips or turnbuckles to the side of
the camper as indicated. Use the camper skirt for positioning the Velcro.
The locations shown are guidelines. If you are using Velcro,
use enough to securely fasten the camper skirt to your
camper.
Top Of
Camper Wall
STEP2
Velcro
• Use the roll of Velcro to cover the top edge of the camper
folding wall. Trim the excess Velcro with scissors.
• Secure the Screen Room fabric to the Velcro from the peak
of the folding wall to the bottom corners.
• Raise the camper wall into position with the Screen Room
fabric pulled to the outside of the camper.
Screen
Room
Fabric
Camper
3