Quick Installation Guide
Unmanaged Ethernet Switch
This document will guide you through the
basic installation process for your new D-Link
Unmanaged Ethernet Switch
Quick Installation Guide
SET UP LED INDICATIONS
ENGLISH
1
2
LED Color State Description
Power
(system)
Link/
Act/
Speed
(port)
Solid Light
Green
Light off
Solid Light
Green
Blinking
Solid Light
Amber
Blinking
Device is
powered on
Device is
powered off
Device connected
at 1000 Mbps
Activity on the
port
Device connected
at 10/100 Mbps
Activity on the
port
RACK INSTALLATION
To install in a rack, attach the mounting brackets
to the switch’s side panels (one on each side) and
secure them with the screws provided. Then, use the
hardware provided with the equipment rack to mount
the switch in the rack.
3
LED
2
Installing a Power Cord
Retainer (For DGS-1024C)
Installation of a power cord retainer is recommended
to prevent accidental removal of the AC power cord.
A. Insert a tie wrap with the rough side facing down
into the hole below the power socket.
D. Wrap the retainer around the power cord and
place the free end into the fastener.
Wrap the retainer around the power cord
ENGLISH
Insert tie wrap
B. Connect the AC power cord into the AC power
inlet of the switch.
Connect the power cord to the switch
C. Attach the retainer to the tie wrap and slide it up to
the end of the cord.
Attach the retainer to the tie wrap
E. Fasten the retainer by pulling on it until secure.
Secure the power cord
F. Connect the AC power cord to an electrical outlet.
Additional Information
Additional help, product and warranty information
is available online at support.dlink.ca (CAN) or
support.dlink.com (USA).
©2018 D-Link Corporation. All rights reserved.
Trademarks or registered trademarks are the property
of their respective holders. Software and specications
subject to change without notice.
3
Ver.1.00(NA)_130X183
2018/09/25
5402054
Loading...