D Link PR1040A1 User Manual
93
Highlight the printer, as shown. If the desired printer is not on the list, click Have
Disk and insert the printer driver disk that came with your printer to install the printer
drivers.
Click Next
94
Click Next to start installing the printer.
95
After clicked Print a test page, a small dialogue box will show up as below. Click
Close.
96
Click Finish.
97
The printer is now ready for printing with Windows Vista on your network.
98
TCP/IP Printing for Windows XP
Go to Start => Printers and Faxes => Add a Printer.
When the following screen shows up, click Next.
99
Select the first option, Local printer attached to this computer, and click Next.
100
Select the second option, Create a new port, and highlight Standard TCP/IP Port
from the pull-down menu. Click Next.
101
Click Next.
102
Type the IP address of the MFP server (e.g. 10.62.31.15 used in this manual), which
can be referred from the PRINTER SERVER STATUS of the MFP server’s Web
configuration, and then the Port Name will automatically be filled in. Click Next
103
Select Custom and click Settings.
104
Then the follow screen will shows up, select LPR from the Protocol field.
Then enter the Queue Name, which can be referred from PRINTER STATUS of the
MFP server’s Web configuration, in the LPR Settings field. Click OK.
105
106
Click Next.
107
Click Finish.
108
Highlight the printer, as shown. If the desired printer is not on the list, click Have Disk
and insert the printer driver disk that came with your printer to install the printer
drivers.
Click Next
109
At this screen, you can input a name for the printer, and then click Next
110
Select Yes to print a test page, click Next.
Click Finish. The printer is now ready for printing with Windows XP on your network.
111
112
TCP/IP Printing for Windows 2000
Go to Start => Settings => Printers and Faxes => Add a Printer.
When the following screen shows up, click Next.
113
Select the first option, Local printer attached to this computer, and click Next.
114
Click Next if New Printer Detection page pops up.
Select the second option, Create a new port, and highlight Standard TCP/IP Port
from the pull-down menu. Click Next.
115
Click Next.
116
Type the IP address of the MFP server (e.g. 10.62.31.15 used in this manual), which
can be checked from the PRINTER SERVER STATUS of the MFP server’s Web
configuration, and then the Port Name will automatically be filled in. Click Next
117
Select Custom and click Settings.
118
Then the follow screen will shows up, select LPR from the Protocol field.
Then enter the Queue Name, which can be referred from PRINTER STATUS of the
MFP server’s Web configuration, in the LPR Settings field. Click OK.
119
120
Loading...