D-link DSN-1000 BROCHURE

Features

Handles Over 80,000 I/Os Per Second



Battery Protected Cache Memory:



256MB Standard (Upgradeable to 1GB)
System Memory: 256MB Standard



(Upgradeable to 512MB)
5 Hot-Swap SATA Hard Drive Bays



5TB Capacity with 1TB Hard Drives



(Supports higher capacity drives as they
are introduced)
SATA-II Support



200 Watt Power Supply



Compact Cube Chassis Fits Anywhere



RAID Support

0, 1, 1+0, and 5



High Performance iSCSI
Interface

Four 1GbE Ports



Storage Network Management

IP SAN Device Manager (IDM)



Remote Monitoring and Configuration



CHAP Authentication Helps Halt



Intruders
SSL Security to Management Console



DSN-1000 Series Managed SAN Solutions

D-Link 4x1GbE iSCSI SAN Array with 5 SATA Bays

The D-Link® DSN-1100-10 4x1GbE iSCSI SAN Array
provides a smaller, more value-oriented solution for
entry-level and SMB customers. The heart of the
DSN-1100 is based on the same powerful System-on-a-Chip
(SoC) design found in larger arrays such as the DSN-3000
Series of products, but housed in a smaller chassis. Utilizing
a 10Gbit iSCSI SoC solution that can handle over 80,000 I/
Os per second, the DSN-1100 is capable of supporting
5TBs of raw capacity using 1TB hard drives (and even
higher capacity hard drives as they are introduced). The
DSN-1100 can easily be implemented as nearline storage
or as a supplement to your primary backup and recovery
device. This evolutionary advancement in performance is
a testament to the tightly integrated storage architecture
and is a sharp contrast to the discrete implementation of
competing products.

iSCSI for IP Networks

SAN has been traditionally reserved for Fibre Channel
networks until the recent introduction of iSCSI extended this
powerful yet simple centralized backend storage system
to IP networks. By utilizing existing Ethernet technology,
the cost associated with separate host bus adapters and
the per-Gigabyte cost for storage is significantly reduced.
iSCSI SANs can leverage the Ethernet infrastructure and
standards that are already familiar to your IT staff.

Four 1GbE Interfaces

The DSN-1100 implements four 1GbE ports that support
IEEE 802.3ad Link Aggregation Groups (LAG) for full offload
capability. This allows all four ports to be grouped together
for up to 425MB/s bandwidth, increasing throughput and
redundancy.

System-on-a-Chip (SoC) Implementation

By utilizing a SoC design, the DSN-1100 combines
both networking and storage functions into a single
specialized Application Specific Integrated Circuit (ASIC).
The SoC solution combines 10Gbps iSCSI, TCP & IP
offload, embedded processors, and storage virtualization
firmware onto a single chip. The tight integration of these
functions eliminates interoperability, timing, and support
issues found in competitive products that offer “discrete
implementation” wherein all the various components are
chosen separately and then assembled. The DSN-1100
outperforms these discrete implementations and does so
at a lower price point, while delivering mission-critical
data quickly with state-of-the-art reliability.

RAID for Efficiency

The DSN-1100 features five hot swappable Serial ATA
(SATA) disk drive bays supporting 5TB raw capacity
using 1TB hard drives (and even higher capacity hard
drives as they are introduced) in RAID level 0, 1, 1+0 and
5 configurations. You can quickly deploy a SAN using
inexpensive SATA disk drives and, depending on your
growing storage needs, you can simply add more drives
as you go.

Embedded Centralized Storage Management

The embedded, user-friendly IP-SAN Device Manager
(IDM) provides comprehensive network storage
management.

Advanced Management Features

The DSN-1100 provides additional advanced features for
efficient management of network storage and optimal
performance.

DSN-1000 Series Managed SAN Solutions

D-Link 4x1GbE iSCSI SAN Array with 5 SATA Bays

Technical Specifications

For the fastest RAID performance offered in the industry,
the D-Link adaptive cache management provides write
coalescing and multi-stream read-ahead on a volume
basis, optimizing cache utilization and performance in
an application-dependent manner. Volatile cache data
protection is afforded via an on-board battery that is
designed to back up to 1GB of cached memory for at least
72 hours.

VLAN Zoning supports IEEE 802.1q VLAN tagging to
segregate traffic into isolated zones for secure access and
jumbo frames, improving network throughput and reducing
CPU overhead.

Volume Virtualization utilizes the concept of storage
Extents. Extents are the fundamental building blocks used
to enable features such as RAID, online capacity expansion
and volume migration. Drives of dissimilar size can be used
to create volumes. Growth can occur without volume
migration or reconstruction. Single drives can contain
multiple and divergent RAID technologies.

RAID Support for RAID Levels 0, 1, 1+0 and 5 (striped sets,
mirrored sets, striped mirrored sets, and parity sets) allows
for different storage options.

Online Capacity Expansion and RAID Level Migration
are performed online with minimal impact on users. For
example, a mirror volume of two drives can easily be
converted to a parity volume of three or more drives while
users continue to access this storage.

Micro Rebuilds provide protection against unresponsive
SATA commands by forcing a response within a preset
time limit.

An iSCSI array can prove to be a valuable tool to supplement
your network storage foundation. Whether providing a
low-cost block-based solution for data backup and recovery,
replacement of Direct-Attached Storage (DAS) drives,
or providing a cost-effective entry-level nearline storage
solution, the DSN-1100 can meet all of your immediate needs.

Features

Drive Bays 5

Drive Interface Support SATA-II Support

System Memory 256MB to 512MB (256MB standard)

Cache Memory 256MB to 1GB (256MB standard)

Battery Backup for Cache Standard (approximately 72 hours on full charge)

Bandwidth Up to 425MB/s

Storage Capacity 5TB capacity with 1TB hard drives (support for higher capacity drives as they are introduced)

Supported NICs, iSCSI Accelerators
and iSCSI HBAs

Please see support.dlink.com for latest
support information

Intel® Pro 1000MT & XT [1GbE]

®

Alacritech

SES2104ET (drivers: SNP 9.1.0.1092 & 7.3.1.0)

Alacritech SES2102ET (drivers: SNP 9.1.0.1092 & 7.3.1.0)

®

4010C, 4052C, & 4062C

QLogic

DSN-1000 Series Managed SAN Solutions

D-Link 4x1GbE iSCSI SAN Array with 5 SATA Bays

Operating Systems Supported

Please see support.dlink.com for latest
support information

iSCSI Network Interface

iSCSI Network Interface Four 1GbE Copper Ports

Host Interface iSCSI Draft 20 compliant initiator

Connections 1,024 hosts

CHAP Authentication Yes

Access Control of Management Yes

iSCSI/TCP/IP Full HW Offload Yes

Jumbo Frames Support Ye s

Link Aggregation Group Support Yes – Up to four LAGs (IEEE802.3ad Link Aggregation Group)

VLAN Support Up to four 1-to-1 mapping between IP subnet and VLAN. Multiple VLANs per physical port with VLAN tag. All physical

Windows Vista® 32-bit & x64 (Ultimate & Enterprise) with Built-in iSCSI initiator

Windows Server

Windows Server 2003 R2 32-bit & x64 (Standard & Enterprise) with v2.07 iSCSI initiator

Windows

Windows 2000 Advanced Server with v1.6 & v2.01 iSCSI initiator

Red Hat

Red Hat Enterprise AS update 5

SuSE Enterprise Server 10.2 32-bit (x86)

®

SuSE

Professional 9.3 32-bit & x64

Mac OS

ports in LAG belong to same VLAN (IEEE802.1Q Tag)

®

2003 32-bit & x64 SP1 (Standard & Enterprise) with v2.07 iSCSI initiator

®

XP Pro 32-bit & x64 with v2.07 iSCSI initiator

®

7.3

®

X (10.4 & 10.5)

Volume & RAID Support

RAID Controller Single- Integrated in ASIC

RAID Support RAID Levels 0, 1, 1+0 and 5

Volumes 1,024 Virtual Volumes (256 accessible per initiator)

Target Nodes 1,024

Online Capacity Expansion Yes

Hot Swappable Drives Yes

Instant Volume Access Yes

Free Space Defragmentation Ye s

Auto-Detection Failed Drive Yes

Auto-Rebuild Spare Drive Yes

RAID Level Migration Yes

Drive Roaming in Power Off
(configured drives are not bay­specific)

Micro Rebuilds Yes

Yes

Storage Management

Embedded IP-based Management
GUI

Firmware Field Upgradeable Yes

Power

Supply Type 1U 200 Watt

Input Voltage 100-240 VAC

Input Frequency 50-60Hz

Input Current 4A

Power Factor Correction 95%@110V, Full load

Power Consumption 112 Watts (full configuration)

Thermal 815 BTU/hour (full configuration)

DSN-1000 Series Managed SAN Solutions

D-Link 4x1GbE iSCSI SAN Array with 5 SATA Bays

Create, manage, expand and monitor storage pool, volumes, and RAID

Event manager to view and persist events

Environmental

Operating Temperature 32° to 104°F (0° to 40°C)

Storage Temperature -4° to 158°F (-20° to 70°C)

Operating Humidity 20% ~ 90% (Non-condensing)

Storage Humidity 10% ~ 95% (Non-condensing)

Physical (approximate)

Form Factor Tower

Dimesnsions (D x W x H) 10.7in x 6.6in x 10.2in (273mm x 167mm x 259mm)

Weight with No Drives Installed 8.8 lbs (4.0 kg)

International Approvals

Emissions CE Class A, FCC Class A, C-Tick Class A, VCCI Class A

Safety CSA 60950-1, UL60950-1, IEC 60950-1, EN 60950-1

All references to speed are for comparison purposes only. Product specifications, size and shape are subject to change without notice, and actual product

appearance may differ from that depicted. See inside package for warranty details.

No. 289 Xinhu 3rd Road, Neihu, Taipei 114, Taiwan

D-Link is a registered trademark of D-Link Corporation and its overseas subsidiaries.

Specifications are subject to change without notice.

All other trademarks belong to their respective owners.

©2009 D-Link Corporation. All rights reserved.

D-Link Corporation

Release 01 (August 2009)